That sounds like the tower is receiving noise that the clients can't hear.
-----Original Message-----
From: Craig House
Sent: Saturday, June 06, 2015 7:19 PM
To: [email protected]
Subject: [AFMUG] EPMP 10 mhz vs 20mhz
We have deployed 6 towers to begin our new EPMP network and 4 of those
towers have a full cluster of 2.4 90 degree EPMP sectors. They are
configured with ACS turned off now because in several cases they all ended
up on the same or very close to the same channel. I have Front back
designations and non overlapping channels set up on all towers. I have
tried 40 mhz 20 mhz and now 10mhz channels and while the customer stability
has gotten better the more I play with settings I have kind of hit a point I
dont know what else to try. I have some that the uplink quality will vary
wildly from 100% to 0%. Most have gotten better since I went to a 10mhz
channel. Most of the customers get 12MB -30mb down in the wireless link
test but the uplinks are as bad as .17. What is the cause of this poor
uplink quality? Is it interfernece? My one 5ghz AP does not have this
problem but even with noise many of these customers have -50 signals and
oddly enough the ones with the great signals seem to be the ones that have
the poorest link tests on the up link side. I also have customes with -65
or -72 signals that get 5MB up on the same sectors? Im scratching my head a
bit on what the fix is for this? Should I leave ACS on and change
everything to 10mhz channels? Will a full cluster with ACS on work all on
the same channel?
I'm used to FSK where you pick your channel and any channels that are
adjacent will cause problems with connected SM's. So am I just applying old
knowledge to a technology that it doesn't apply to?
Craig
