It didn't like encapsulation. Tab complete also didn't have anything for it.
It's ignoring the simple description command. It takes it, but then show config just doesn't say anything. ----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com ----- Original Message ----- From: "Rob Genovesi" <r...@corp.coastside.net> To: af@afmug.com Sent: Saturday, June 13, 2015 2:28:42 PM Subject: Re: [AFMUG] Cisco pissing me off You may be missing this cmd: switchport trunk encapsulation dot1q interface FastEthernet 0/3 switchport trunk encapsulation dot1q switchport trunk allowed vlan 777 switchport mode trunk -Rob On Sat, Jun 13, 2015 at 12:22 PM, Mike Hammett < af...@ics-il.net > wrote: This should be a trivial Cisco switch question. Apparently I don't use these turds enough to remember everything. show config says: interface FastEthernet0/3 switchport access vlan 777 switchport mode access speed 100 duplex full no cdp enable ! However, when trying to convert it to a tagged port with the following commands, it doesn't change. config terminal int Fa0/3 switchport mode trunk switchport trunk allowed vlan 777 No errors, just no change. I even tried just setting the description. Same result. I also tried removing the vlan via: interface FastEthernet 0/3 no switchport mode access no switchport access vlan 777 ----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com