are we missing ... wr mem (write to memory to commit the change ?)
?? Faisal Imtiaz Snappy Internet & Telecom 7266 SW 48 Street Miami, FL 33155 Tel: 305 663 5518 x 232 Help-desk: (305)663-5518 Option 2 or Email: supp...@snappytelecom.net ----- Original Message ----- > From: "Mike Hammett" <af...@ics-il.net> > To: af@afmug.com > Sent: Saturday, June 13, 2015 3:36:47 PM > Subject: Re: [AFMUG] Cisco pissing me off > *sigh* show config just tells you what's in NV ram... show running-config > tells you what's actually there now... > ----- > Mike Hammett > Intelligent Computing Solutions > http://www.ics-il.com > ----- Original Message ----- > From: "Mike Hammett" <af...@ics-il.net> > To: af@afmug.com > Sent: Saturday, June 13, 2015 2:34:57 PM > Subject: Re: [AFMUG] Cisco pissing me off > Well, show config doesn't show any changes is what I meant. It still has > stuff, just the same stuff it had before. > ----- > Mike Hammett > Intelligent Computing Solutions > http://www.ics-il.com > ----- Original Message ----- > From: "Mike Hammett" <af...@ics-il.net> > To: af@afmug.com > Sent: Saturday, June 13, 2015 2:33:56 PM > Subject: Re: [AFMUG] Cisco pissing me off > It didn't like encapsulation. Tab complete also didn't have anything for it. > It's ignoring the simple description command. It takes it, but then show > config just doesn't say anything. > ----- > Mike Hammett > Intelligent Computing Solutions > http://www.ics-il.com > ----- Original Message ----- > From: "Rob Genovesi" <r...@corp.coastside.net> > To: af@afmug.com > Sent: Saturday, June 13, 2015 2:28:42 PM > Subject: Re: [AFMUG] Cisco pissing me off > You may be missing this cmd: switchport trunk encapsulation dot1q > interface FastEthernet 0/3 > switchport trunk encapsulation dot1q > switchport trunk allowed vlan 777 > switchport mode trunk > -Rob > On Sat, Jun 13, 2015 at 12:22 PM, Mike Hammett < af...@ics-il.net > wrote: > > This should be a trivial Cisco switch question. Apparently I don't use > > these > > turds enough to remember everything. > > > show config says: > > > interface FastEthernet0/3 > > > switchport access vlan 777 > > > switchport mode access > > > speed 100 > > > duplex full > > > no cdp enable > > > ! > > > However, when trying to convert it to a tagged port with the following > > commands, it doesn't change. > > > config terminal > > > int Fa0/3 > > > switchport mode trunk > > > switchport trunk allowed vlan 777 > > > No errors, just no change. I even tried just setting the description. Same > > result. > > > I also tried removing the vlan via: > > > interface FastEthernet 0/3 > > > no switchport mode access > > > no switchport access vlan 777 > > > ----- > > > Mike Hammett > > > Intelligent Computing Solutions > > > http://www.ics-il.com >