Well, show config doesn't show any changes is what I meant. It still has stuff, just the same stuff it had before.
----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com ----- Original Message ----- From: "Mike Hammett" <af...@ics-il.net> To: af@afmug.com Sent: Saturday, June 13, 2015 2:33:56 PM Subject: Re: [AFMUG] Cisco pissing me off It didn't like encapsulation. Tab complete also didn't have anything for it. It's ignoring the simple description command. It takes it, but then show config just doesn't say anything. ----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com ----- Original Message ----- From: "Rob Genovesi" <r...@corp.coastside.net> To: af@afmug.com Sent: Saturday, June 13, 2015 2:28:42 PM Subject: Re: [AFMUG] Cisco pissing me off You may be missing this cmd: switchport trunk encapsulation dot1q interface FastEthernet 0/3 switchport trunk encapsulation dot1q switchport trunk allowed vlan 777 switchport mode trunk -Rob On Sat, Jun 13, 2015 at 12:22 PM, Mike Hammett < af...@ics-il.net > wrote: This should be a trivial Cisco switch question. Apparently I don't use these turds enough to remember everything. show config says: interface FastEthernet0/3 switchport access vlan 777 switchport mode access speed 100 duplex full no cdp enable ! However, when trying to convert it to a tagged port with the following commands, it doesn't change. config terminal int Fa0/3 switchport mode trunk switchport trunk allowed vlan 777 No errors, just no change. I even tried just setting the description. Same result. I also tried removing the vlan via: interface FastEthernet 0/3 no switchport mode access no switchport access vlan 777 ----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com