Yeah, the LEDs will run at such a low voltage that they still run after a fuse blows on my system. Apparently the DC distribution panel still lets a small amount of power through aven after the fuses are blown. Hopefully that doesn't affect the protection level, but I found it odd.
On Wed, Sep 9, 2015 at 8:37 AM, Josh Luthman <[email protected]> wrote: > Isn't AF24 only 48v? > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Wed, Sep 9, 2015 at 10:33 AM, Chuck McCown <[email protected]> wrote: > >> OK, there are some half watt resistors in that area. When running at 55 >> volts limiting current for the LEDs they do get hot. Their temp depends on >> system voltage. I had hard to make the LEDs usable for a range of 6-60 >> volts without some tradeoff. >> >> As long as the large chip isn’t getting hot you are OK. >> >> *From:* Josh Baird <[email protected]> >> *Sent:* Wednesday, September 09, 2015 8:16 AM >> *To:* [email protected] >> *Subject:* Re: [AFMUG] GIGE-POE-APC Hot? >> >> Yeah, it seems to be just the area around the LED. The connector is not >> very hot at all. >> >> On Wed, Sep 9, 2015 at 9:54 AM, Nate Burke <[email protected]> wrote: >> >>> Or is it the area right by the LED's? >>> >>> On 9/9/2015 8:52 AM, Ken Hohhof wrote: >>> >>> The connector is hot? That can’t be right. >>> >>> *From:* Josh Baird <[email protected]> >>> *Sent:* Wednesday, September 09, 2015 8:43 AM >>> *To:* [email protected] >>> *Subject:* [AFMUG] GIGE-POE-APC Hot? >>> >>> We just installed our first GIGE-POE-APC which is powering an AF24, and >>> noticed that it gets VERY hot. So hot that it almost instantly burns your >>> finger when you touch the green molding. For folks that have these >>> installed, is this normal? >>> >>> It's ran fine for a few days, but this morning we we noticed that the >>> ethernet link on the AF24 was dropping (and coming back very quickly). I'm >>> not sure if it's related or not. >>> >>> Josh >>> >>> >>> >> > >
