what do you use to "see" the signals? Most FHSS move so fast Airview doesn't catch it very well.
Jaime Solorza Wireless Systems Architect 915-861-1390 On Thu, Dec 17, 2015 at 9:48 AM, Bill Prince <part15...@gmail.com> wrote: > The smart meters here do a mesh/hub system. All the meters talk to each > other doing a FHSS mesh. > > They figure out where the nearest hub is, and all the meters in a > neighborhood relay their information to the hub through the meter(s) that > are closest to the hub. So they are chatting all the time, and the ones > closest to the hub never stop. > > > bp > <part15sbs{at}gmail{dot}com> > > On 12/17/2015 8:39 AM, Adam Moffett wrote: > >> I know I'm late to this thread. The only smart meter system in this area >> is a polling system. The meter reader just drives down the street while >> his truck transmits a polling message, which the meters then reply to. The >> meters only speak when spoken too, so we never really had a problem with >> those. There's still a huge labor savings for the power company, and >> apparently it was a lot cheaper than deploying the mesh system from the >> same manufacturer. >> >> What I infer from these threads is the effect of this smart meter stuff >> is heavily dependent on what equipment the power company bought, how it's >> deployed, and how it's configured. So yeah, YMMV is the only real answer. >> >> On 12/16/2015 9:16 AM, Eric Muehleisen wrote: >> >>> Interesting. The majority of our 900 subs are located in prime smart >>> meter territory. I've worked with several of the power companies >>> across western Kansas and they all run a version of Landis Gyr meters >>> with is FHSS 900 ISM (see pic here >>> https://dl.dropboxusercontent.com/u/1578608/Public/smart_meter.jpeg) >>> >>> They transmit infrequently in short bursts...very little data. The >>> only time we see interference is when they mass update software. After >>> some discussion, we convinced them to run updates during our non-peak >>> times. So far we've been able to co-exist peacefully. YMMV. >>> >>> On Tue, Dec 15, 2015 at 7:38 PM, Ken Hohhof <af...@kwisp.com> wrote: >>> >>>> Everywhere. >>>> >>>> Smartgrid is probably the main culprit. >>>> >>>> And without LOS, all signals get scattered by the same foliage and other >>>> obstacles that are scattering the signal you are trying to pick up. So >>>> literally, the interference sources are everywhere. Sometimes I blame >>>> the >>>> midichlorians. >>>> >>>> >>>> From: Jaime Solorza >>>> Sent: Tuesday, December 15, 2015 7:28 PM >>>> To: Animal Farm >>>> Subject: Re: [AFMUG] 900 MHz 450i report >>>> >>>> >>>> Where is the noise coming from? >>>> >>>> On Dec 15, 2015 6:19 PM, "Ken Hohhof" <af...@kwisp.com> wrote: >>>> >>>>> We swapped out an FSK AP in a high interference area today. No magic, >>>>> works about the same. >>>>> >>>>> Too bad, even the installer liked the SM and antenna. Even the coax >>>>> boots >>>>> are nice. >>>>> >>>>> Will probably work well for those of you who don't have -65 noise >>>>> floors. >>>>> >>>>> We are going to have to give up on 900 MHz at this location. This was >>>>> the >>>>> last gasp. >>>>> >>>>> >> >