Yep. Dymo 5200 and vinyl label tape gets used when it gets to the site.
Best $100 I ever spent.
On 8/18/2016 9:53 AM, Mark Radabaugh wrote:
Wire labels, terminal labels, and fuse labels.
My pet peeve. It’s pretty now, but when parts get ripped out at 2 in the
morning after the lightning strike can you really remember what cable was in
which port? That wiring won’t be so pretty once people start yanking on wires
to figure out which fuse power what.
Mark
On Aug 18, 2016, at 12:51 AM, George Skorup <[email protected]> wrote:
This is for a retrofit at an ugly FM site. Wiring is a bit messy, but meh. Used
two separate blank panel because I had them.
Traco TSP360-148 + BCM48 (only one I bought, figured might as well use it;
BCMU360 from now on). There's a RSD150C-24 hiding behind the DDFL4U fuse
blocks. PacketFlux 2-relay/3-switch module to monitor the status contacts on
the BCM. 10A shunt on the negative side of the battery feed going into the BCM.
PowerInjector + Sync for the 450 cluster. 5ch PDU on the end feeding
GIGE-POE-APCs for an AF24 and an Exalt ExtendAir G2-11. Still got a bunch of
old shit on the tower which is what the 8-port injector is for.
We'll see how crappily the RB1100 does. Had it sitting around doing nothing.
Might just end up swapping it for an AHx2.
Can't wait to get my hands on Forrest's new injectors so wiring won't have to
be this complicated anymore.
<Mail Attachment.jpeg>
