The terminal blocks on the bottom are the DDFL4U double-level, top
fused. The left four is my +48 bus, end plate used as a separator, then
the 10 on the right is the +24 bus.
On 8/18/2016 8:43 AM, Matt wrote:
On the bottom where did you get the DIN mount terminal strip?
On Wed, Aug 17, 2016 at 11:51 PM, George Skorup <[email protected]
<mailto:[email protected]>> wrote:
This is for a retrofit at an ugly FM site. Wiring is a bit messy,
but meh. Used two separate blank panel because I had them.
Traco TSP360-148 + BCM48 (only one I bought, figured might as well
use it; BCMU360 from now on). There's a RSD150C-24 hiding behind
the DDFL4U fuse blocks. PacketFlux 2-relay/3-switch module to
monitor the status contacts on the BCM. 10A shunt on the negative
side of the battery feed going into the BCM. PowerInjector + Sync
for the 450 cluster. 5ch PDU on the end feeding GIGE-POE-APCs for
an AF24 and an Exalt ExtendAir G2-11. Still got a bunch of old
shit on the tower which is what the 8-port injector is for.
We'll see how crappily the RB1100 does. Had it sitting around
doing nothing. Might just end up swapping it for an AHx2.
Can't wait to get my hands on Forrest's new injectors so wiring
won't have to be this complicated anymore.
