Hmm...maybe it doesn't need two radios, but two antennas. Like a
spatial diversity setup.
I wonder if McCown makes parts for that.
------ Original Message ------
From: "Chris Fabien" <ch...@lakenetmi.com>
To: af@afmug.com
Sent: 9/13/2016 12:02:57 PM
Subject: Re: [AFMUG] Wooden pole twisting
May not be a viable solution with an 11 ghz backhaul, but you could
install two radios, once that is on target in summer and one in winter,
and switch between them without climbing at least.
On Tue, Sep 13, 2016 at 11:13 AM, Robert <i...@avantwireless.com>
wrote:
When you look at the high voltage distribution lines with twin poles
they through bolt hanger connectors on the poles and then hang the
cross braces across the hangers. Poles twisting then doesn't do
anything but put tension or compression on the cross bracing...
Unless the poles actually start to lean, the cross bracing stays
pretty much immobile.. But putting two poles up pretty much brings
it to the price of a tower.
On 9/13/16 7:54 AM, Adam Moffett wrote:
I imagine the pole would win that tug of war over time.
Looking at a photo of this pole, it has a noticeable curvature near
the top. Maybe we'll move the dish below the curve and see if that
helps.
------ Original Message ------
From: "Jay Weekley" <par...@cyberbroadband.net>
To: af@afmug.com
Sent: 9/13/2016 10:44:11 AM
Subject: Re: [AFMUG] Wooden pole twisting
For us they are and haven't hand problems with twisting. We've got
one with a link that's been steady for 6 years or more. The problem
is accessing the link on short notice since we don't know a bucket
truck and operators are very busy. It seems like you could put two
wood posts on either side of the pole and secure a 4x4 with large
lag screws to keep it from twisting.
Matt wrote:
I wonder if painting would help keep moisture out? Maybe its a
temperature thing too?
I always thought wood poles would be great for CPE locations but
now maybe not.
On Tue, Sep 13, 2016 at 3:44 AM, Adam Moffett <dmmoff...@gmail.com>
wrote:
I've got a 70' (61' AGL) class 3 pole with an AP and backhaul on
it. It's
been in the ground about 3 years now.
This past spring we noticed the signal drop slowly on the backhaul
over the
course of a month. A climber went up and adjusted it by about 9
degrees,
but he said the mount was tight when he got there. This past
month the RSSI
on the backhaul has been slowly dropping again.
The humidity here tends to shoot way up in the summer and drop in
the
winter. I'm supposing this beast must be twisting as it soaks up
moisture
and then dries out again.
Is this a problem that might diminish as the pole ages, or is
there perhaps
any possible remediation? I guess the permanent fix is a real
tower or a
steel pole, but I guess I'm hoping that one of you old phone guys
knows some
magic trick. Seems like if there was a wire attached to this
pole, that a 9
degree twist would put some wicked tension on it.
