Yes -64 before I changed dishes and turned up the power a bit. Link planner showed -64 also. I'm getting it on all but one chain.
Sent from my iPhone > On Oct 17, 2016, at 18:46, Josh Luthman <j...@imaginenetworksllc.com> wrote: > > Do you remember what ideal was supposed to be? Hopefully -64? > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > >> On Mon, Oct 17, 2016 at 7:44 PM, Craig House <cr...@totalhighspeed.net> >> wrote: >> The antennas were set to 23 DB antennas and I change them up after I took >> this picture to 30 DBI dishes that I'm using. It did change the ideal >> signal but it didn't change the actual signal >> >> Sent from my iPhone >> >>> On Oct 17, 2016, at 18:41, Josh Luthman <j...@imaginenetworksllc.com> wrote: >>> >>> Do you have your power/antennas set right? Between those two points and >>> the set power levels you're supposed to see -53... >>> >>> >>> Josh Luthman >>> Office: 937-552-2340 >>> Direct: 937-552-2343 >>> 1100 Wayne St >>> Suite 1337 >>> Troy, OH 45373 >>> >>>> On Mon, Oct 17, 2016 at 7:37 PM, Craig House <cr...@totalhighspeed.net> >>>> wrote: >>>> It's always been pretty accurate in the past and I have a pretty wide-open >>>> view I'm 85 feet up on the water tower that sits on a mountaintop on one >>>> end and I'm 200 feet up on the building roof top on the other end. The odd >>>> part is that I am achieving that -65 signal on at least one of the chains. >>>> I have a feeling that it resting on the top of the tank is possibly >>>> causing some weird reflection >>>> >>>> Sent from my iPhone >>>> >>>>> On Oct 17, 2016, at 18:34, Josh Luthman <j...@imaginenetworksllc.com> >>>>> wrote: >>>>> >>>>> Doesn't include land cover I bet >>>>> >>>>> Josh Luthman >>>>> Office: 937-552-2340 >>>>> Direct: 937-552-2343 >>>>> 1100 Wayne St >>>>> Suite 1337 >>>>> Troy, OH 45373 >>>>> >>>>> >>>>>> On Oct 17, 2016 7:25 PM, "Craig House" <cr...@totalhighspeed.net> wrote: >>>>>> Wink planner shows that it supposed to be a -65 signal >>>>>> >>>>>> Sent from my iPhone >>>>>> >>>>>>> On Oct 17, 2016, at 18:20, Josh Luthman <j...@imaginenetworksllc.com> >>>>>>> wrote: >>>>>>> >>>>>>> Plug into LinkPlanner >>>>>>> >>>>>>> Josh Luthman >>>>>>> Office: 937-552-2340 >>>>>>> Direct: 937-552-2343 >>>>>>> 1100 Wayne St >>>>>>> Suite 1337 >>>>>>> Troy, OH 45373 >>>>>>> >>>>>>> >>>>>>>> On Oct 17, 2016 7:11 PM, "Craig House" <cr...@totalhighspeed.net> >>>>>>>> wrote: >>>>>>>> Very close to the top of the water tower on the remote end. It bottom >>>>>>>> of the dish is resting on hr tank because the mount wasn't stable >>>>>>>> enough with all the wind here today 45mph. I'll raise it up and brace >>>>>>>> the mount tomorrow and see what happens. >>>>>>>> >>>>>>>> Sent from my iPhone >>>>>>>> >>>>>>>> > On Oct 17, 2016, at 18:03, David Kunat <m...@davidkunat.com> wrote: >>>>>>>> > >>>>>>>> > There are only two polarities on th af-x series. >>>>>>>> > >>>>>>>> > The first two are the receive signals at the local device. >>>>>>>> > >>>>>>>> > The second two (Rem chain0 and Rem chain 1) are the remote device >>>>>>>> > receive levels (at the far end of the link). >>>>>>>> > >>>>>>>> > Is there something in the way? Are you shooting close to the ground >>>>>>>> > or close to tree tops on one end? >>>>>>>> > >>>>>>>> > >>>>>>>> > > On Oct 17, 2016, at 2:39 PM, Craig House >>>>>>>> > > <cr...@totalhighspeed.net> wrote: >>>>>>>> > > >>>>>>>> > > So when you have one chain that shows almost 20 dbi weaker than >>>>>>>> > > the other 3 how do you tell which end to troubleshoot? I have >>>>>>>> > > already tried to point both ends better but they are 22 miles >>>>>>>> > > apart by air. 45 minutes by drive and I dont want to just keep >>>>>>>> > > driving and climbing if someone can tell me which end has the >>>>>>>> > > problem. >>>>>>>> > > >>>>>>>> > > Craig >>>>>>>> > > <link.PNG> >
