So this looks like as good of a place as any to provide this tidbit: I finally found the component I was looking for to complete the cambium sync design here, and I now have a breadboarded solution to sync Medusa (and 450i) via 'cambium sync) here. Seems to be working. I'm in the process of getting the design on a prototype board for the rackmount injector. This *is* going to be more expensive than the non-cambium sync version, but for roughly the price of just that controller, you should be able to get the rackmount chassis+controller plus either 8 of injection, and a syncbox GPS receiver. For probably around $1200 or so, you should be able to get a fully loaded one with 16 ports of sync.
I'm *not* holding this injector for this for reasons I described in earlier threads, but add a month or two after WISPAMERICA and this should be shipping. -forrest On Fri, Feb 17, 2017 at 10:13 AM, Vlad Sedov <v...@atlasok.com> wrote: > The only reason we got this is to properly sync our Medusa APs from the > base of the tower, and maintain a clean gigabit ethernet link. > If Forrest had a product that did the same thing, we would be all over it. > Literally every other piece of GPS sync hardware we use is from PacketFlux. > > > Vlad > > > On 2/17/2017 11:09 AM, Mathew Howard wrote: > > You could also buy all the parts to do the same thing with PacketFlux gear > for a whole lot less than $800... I don't think the actual cost of building > the hardware has much to do with the price of a CMM > > On Fri, Feb 17, 2017 at 10:55 AM, Adam Moffett <dmmoff...@gmail.com> > wrote: > >> You couldn't write the software for it for $100. >> >> Are you looking at a prototype or a finished product? Link? >> >> >> >> ------ Original Message ------ >> From: "Vlad Sedov" <v...@atlasok.com> >> To: af@afmug.com >> Sent: 2/17/2017 11:53:31 AM >> Subject: Re: [AFMUG] CMM5 controller.. Are you serious, Cambium? >> >> No doubt, but for $800, I would expect something a bit more um.. rugged. >>> I can build this for about $100. >>> >>> >>> Vlad >>> >>> On 2/17/2017 10:36 AM, Adam Moffett wrote: >>> >>>> Just like you, they're in business to make money. >>>> >>>> >>>> ------ Original Message ------ >>>> From: "Vlad Sedov" <v...@atlasok.com> >>>> To: "af@afmug.com" <af@afmug.com> >>>> Sent: 2/17/2017 10:31:01 AM >>>> Subject: [AFMUG] CMM5 controller.. Are you serious, Cambium? >>>> >>>> $700-900 for a $35 Raspberry Pi controller, a DC-DC regulator, and a >>>>> metal box? >>>>> Looks like OpenWRT-type Linux distro with LuCI web interface, and a >>>>> module to control the CMM5. >>>>> >>>>> Seems a bit steep, no? >>>>> >>>>> >>>>> peace >>>>> >>>>> Vlad >>>>> >>>> >>>> >>> >> > > -- *Forrest Christian* *CEO**, PacketFlux Technologies, Inc.* Tel: 406-449-3345 | Address: 3577 Countryside Road, Helena, MT 59602 forre...@imach.com | http://www.packetflux.com <http://www.linkedin.com/in/fwchristian> <http://facebook.com/packetflux> <http://twitter.com/@packetflux>