These are the ones I use on panels and end devices most of the time for SCADA projects. Electricians use them as well when they pull wire for us...once tested and certified, we make our heat shrink and non heat shrink Brady ID labels never remove the original ones. We reposition if necessary..
https://www.homedepot.com/p/Ideal-Wire-Marker-Booklet-Legend-10-Pack-44-103/100118633 Jaime Solorza On Dec 28, 2017 8:16 AM, "Jaime Solorza" <[email protected]> wrote: Here you go... several ways to get it done.. https://www.cableorganizer.com/cable-identification/ Jaime Solorza On Dec 28, 2017 8:12 AM, <[email protected]> wrote: > Sharpie works but is difficult to do well and rubs off. > You could use strips of tape and sharpie to do a binary code. > Tape, tape, sharpie, tape = 13 > > -----Original Message----- From: Nate Burke Sent: Thursday, December 28, > 2017 8:06 AM To: Animal Farm Subject: [AFMUG] Office Wire labeling > I'm getting ready to pull some Cat5 into an office space, about 40 drops. > What's the best way to label the cables as they are pulled before they are > dressed/punched. Printing a label for each cable that's going to get cut > off as it's dressed into the patch panel seems wasteful. Colored tape > could work, but may get cumbersome with the combinations. Is writing the > drop number on the jacket with a Sharpie the best way? >
