Hi,
I have a strange problem with my backup system. Everything worked the other
day - until I rebooted the server. The system consists of Redhat 5.2,
amanda-2.4.1p1, Exabyte 8700.
Here is the output of mt status:
[bin@mail sbin]$ mt status
SCSI 2 tape drive:
File number=0, block number=0, partition=0.
Tape block size 0 bytes. Density code 0x0 (default).
Soft error count since last status=0
General status bits on (40050000):
BOT DR_OPEN IM_REP_EN
dmesg:
(scsi0) <Adaptec AHA-2940A Ultra SCSI host adapter> found at PCI 10/0
(scsi0) Narrow Channel, SCSI ID=7, 3/255 SCBs
(scsi0) Warning - detected auto-termination
(scsi0) Please verify driver detected settings are correct.
(scsi0) If not, then please properly set the device termination
(scsi0) in the Adaptec SCSI BIOS by hitting CTRL-A when prompted
(scsi0) during machine bootup.
(scsi0) Cables present (Int-50 NO, Ext-50 YES)
(scsi0) Downloading sequencer code... 419 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.2/3.2.4
<Adaptec AHA-2940A Ultra SCSI host adapter>
scsi : 1 host.
Vendor: EXABYTE Model: EXB-8505 Rev: 0051
Type: Sequential-Access ANSI SCSI revision: 02
Detected scsi tape st0 at scsi0, channel 0, id 2, lun 0
(scsi0:0:2:0) Synchronous at 5.0 Mbyte/sec, offset 11.
scsi : 0 hosts.
st: Unloaded.
However, when I run Amcheck:
[bin@mail sbin]$ ./amcheck seascape
Amanda Tape Server Host Check
-----------------------------
/var/amanda/spool: 6608043 KB disk space available, that's plenty.
insert tape into slot 11 and press return
It appears not to detect a tape in the drive (any tape i put in there). All
the tapes "are" labeled correctly (recently been used). I don't know if I
might have a hardware problem or an amanda configuration problem.
The backup system wasn't configured by me -- it was already setup when I
took over the position. Any suggestions appreciated.
Shane
