Finally, some one actually read the manual!
The alignment is actually quite simple once youve been thru it once.
The way we determined which way to move that wire was to insert a plastic
rod with a piece of aluminum glued on one end and powdered iron on the
other. Aluminum decreases the inductance and iron increases it.
Carl
KM1H
National Radio 1963-69
Service Tech, Service Mgr
Member of NCL-2000 Design Team
----- Original Message -----
From: "Larry Will" <[EMAIL PROTECTED]>
To: "Discussion of AM Radio in the Amateur Service"
<amradio@mailman.qth.net>
Sent: Monday, November 26, 2007 5:38 PM
Subject: Re: [AMRadio] HRO-50
Mike,
My book indicates, like many National receivers, on D band a single loop
of wire inside of the coil is bent to add/subtract inductance. I just
looked at my RF input coil (opened it up) and there is the wire.
The wire is accessible through the left rear hole, looking from the top of
the assembly (the side with the contacts).
Se page 19 in the HRO50-1 National manual for all the coils.
I have seen some cases on some receivers (not an HRO-50) where the range
may not be sufficient.
Larry
W3LW
11111
At 04:03 PM 11/26/2007, you wrote:
What a pain in the scrote. The manual says to adjust the coils for the low
end of the band, (in this case, I'm using coil set D 1.8-4.0M GC 3,5-4.0
BS)
and there aren't any adj. available. I looked in the in each coil set and
I
can see the coil but it looks as though it was designed not to be adj. and
I'm hesitant about attempting to adj. them. The only one that has an
adjustment for GC is D-4. It worked well on 160 but it was damn near deaf
on
75M. I wanted to make it back to standard but its a real tough go. I
should
have left well enough alone. Well, in for a penny, in for a pound.
Mod-U-Lator,
Mike(y)
W3SLK
----- Original Message -----
From: Jim Wilhite
To: Discussion of AM Radio in the Amateur Service
Sent: Monday, November 26, 2007 3:22 PM
Subject: Re: [AMRadio] HRO-50
Fun isn't it Mike. That is the way. If there is an easier way, I would
like to see it.
Jim/W5JO
______________________________________________________________
Our Main Website: http://www.amfone.net
AMRadio mailing list
List Rules (must read!): http://w5ami.net/amradiofaq.html
List Home: http://mailman.qth.net/mailman/listinfo/amradio
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:AMRadio@mailman.qth.net
To unsubscribe, send an email to [EMAIL PROTECTED] with
the word unsubscribe in the message body.