I noticed that when I try to do the "iwconfig wifi0 key XXXXX" commands,
the kernel prints following error in dmesg:

*wifi0: could not initialize WEP: load module hostap_crypt_wep.0*

Both kernel-module-hostap and kernel-module-hostap-cs packages are already
installed. What package includes the kernel module?

--
Arie



On Wed, Nov 2, 2011 at 18:52, Arie Skliarouk <sklia...@gmail.com> wrote:

> I followed the instructions and managed to boot my Collie with the distro
> (basic console-only one).
>
> For some reason USB networking keeps disconnecting after couple of minutes
> (dmesg):
>
> *collie_bat_gpio irq: 1048576
> sa1100_udc: Resetting
> ep1_start [995]: write 0x3f to f8000008 (0x8) failed
> usbep0: write_fifo: write failure
> usbep0: write_fifo: write failure
> usbep0: write_fifo: write failure*
>
> If I disconnect the device from USB and reconnect it, it works again for
> couple more minutes.
>
> I then tried an CF WiFi card - it found the wifi network but I could not
> set up the WEP encryption:
> * root@collie:~# iwconfig wlan0 key 112233beaf
> Error for wireless request "Set Encode" (8B2A) :
>     SET failed on device wlan0 ; Operation not supported.*
>
> Any clues?
>
> --
> Arie
>
>
_______________________________________________
Angstrom-distro-users mailing list
Angstrom-distro-users@linuxtogo.org
http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-users

Reply via email to