Sent too early, the required kernel module was lib80211_crypt_wep.ko and it is provided by the kernel-module-lib80211-crypt-wep package. This is worthwhile to be put into the wiki page.
-- Arie On Thu, Nov 3, 2011 at 09:44, Arie Skliarouk <sklia...@gmail.com> wrote: > I noticed that when I try to do the "iwconfig wifi0 key XXXXX" commands, > the kernel prints following error in dmesg: > > *wifi0: could not initialize WEP: load module hostap_crypt_wep.0* > > Both kernel-module-hostap and kernel-module-hostap-cs packages are already > installed. What package includes the kernel module? > > -- > Arie > > > > > On Wed, Nov 2, 2011 at 18:52, Arie Skliarouk <sklia...@gmail.com> wrote: > >> I followed the instructions and managed to boot my Collie with the distro >> (basic console-only one). >> >> For some reason USB networking keeps disconnecting after couple of >> minutes (dmesg): >> >> *collie_bat_gpio irq: 1048576 >> sa1100_udc: Resetting >> ep1_start [995]: write 0x3f to f8000008 (0x8) failed >> usbep0: write_fifo: write failure >> usbep0: write_fifo: write failure >> usbep0: write_fifo: write failure* >> >> If I disconnect the device from USB and reconnect it, it works again for >> couple more minutes. >> >> I then tried an CF WiFi card - it found the wifi network but I could not >> set up the WEP encryption: >> * root@collie:~# iwconfig wlan0 key 112233beaf >> Error for wireless request "Set Encode" (8B2A) : >> SET failed on device wlan0 ; Operation not supported.* >> >> Any clues? >> >> -- >> Arie >> >> > _______________________________________________ Angstrom-distro-users mailing list Angstrom-distro-users@linuxtogo.org http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-users
