hi all .
i try again to install arm to raspberry pi 3 .
i use miniroot61.fs of 6th april version .
insert micro sd card(S1) with usb card reader(which has micro sd card(S2)).
at the end of installing
------------------------>
Set name(s)? (or 'abort' or 'done') [done]
Get/Verify SHA256.sig 100% |**************************| 1381 00:00
Signature Verified
Get/Verify bsd 100% |**************************| 5433 KB 00:36
Get/Verify bsd.rd 100% |**************************| 11059 KB 01:15
Get/Verify base61.tgz 100% |**************************| 75067 KB 08:03
Installing bsd 100% |**************************| 5433 KB 00:00
Installing bsd.rd 100% |**************************| 11059 KB 00:01
Installing base61.tgz 100% |**************************| 75067 KB 02:10
Extracting etc.tgz 100% |**************************| 189 KB 00:01
Location of sets? (disk http nfs or 'done') [done]
Time appears wrong. Set to 'Sat Apr 8 09:43:37 JST 2017'? [yes]
Saving configuration files...done.
Making all device nodes...done.
# df
Filesystem 512-blocks Used Avail Capacity Mounted on
/dev/rd0a 14823 13150 1673 89% /
/dev/sd0a 15446556 573924 14100308 4% /mnt
/dev/sd0i 32668 6636 26032 20% /mnt/mnt
halt -p
---------------------<
then i insert micro sd card(S2) and power on
--------------------->>
smsc0 at uhub1 port 1 configuration 1 interface 0 "Standard Microsystems
SMSC953
smsc0: address b8:27:eb:c3:cc:1a
ukphy0 at smsc0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x0001fc
umass0 at uhub1 port 2 configuration 1 interface 0 "Generic Mass Storage
Device4
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <Multi, Flash Reader, 1.00> SCSI0 0/direct
remova1
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
bootfile: sd0a:/bsd
boot device: sd0
panic: root device (22692e8a0bb8a762) not found
Stopped at panic+0x158: TID PID UID PRFLAGS
PFLAGS C
PU COMMAND
* 0 0 0 0x10000 0x200 0 swapper
Debugger() at panic+0x154
panic() at diskconf+0xac
diskconf() at main+0x46c
main() at $x.2+0x70
https://www.openbsd.org/ddb.html describes the minimum info required in bug
reports. Insufficient info makes it difficult to find and fix bugs.
ddb>
-------------------<<
i think the day which raspberry pi 3 runs openbsd will be near future .
-
regards
