On Thu, Jan 13, 2011 at 8:43 AM, Tao Jin <jintao....@gmail.com> wrote: > Dear all, > > I have a Linksys WRT160NL router, which has a 802.11n chip, and runs > OpenWRT firmware with ath9k driver. This driver is built from > compat-wireless-2010-12-16 snapshot. > > I set up the router as g mode only, and rate control algorithm is by > default minstrel-ht. > > I test iperf UDP downlink throughput from the router to a laptop. The > performance is not quite consistent, and fluctuate quite a bit, > ranging from 10Mbps - 20Mbps at most time. There is not likely to be > high interference in my test environment. And the two nodes are > placed pretty close to each other. > > My questions are: > > 1. Could any developer provide some reference performance result for > ath9k at this stage? > 2. Will there be any known issue if I set the driver to operate in g > mode only, but use ath9k and minstrel-ht rate algorithm?
May be you can try with ath9k-rate control. If there is no interference I could not figure whats the problem. Generally I observe down link < up link throughput I could say we should get at least 21Mbps on an average > > > Thanks tons in advance! > > jintao > _______________________________________________ > ath9k-devel mailing list > ath9k-devel@lists.ath9k.org > https://lists.ath9k.org/mailman/listinfo/ath9k-devel > _______________________________________________ ath9k-devel mailing list ath9k-devel@lists.ath9k.org https://lists.ath9k.org/mailman/listinfo/ath9k-devel
