vett93;687430 Wrote: > Flat to 18Hz by what weighting method? One of my subwoofers is in my 2nd > system. I set the cross over freq. at 40Hz and use the speaker level > input. If I use A or C weighting method on my sound level meter to flat > out the freq response, I find the low bass is a bit too weak for my > taste. I ended up adjusting the gain of the subwoofer up a tad for my > 2nd system.
Flat as measured in-room by Audiolense and my Earthworks mic after applying Inguz DRC. flat is flat in this case :-) Not A-weighted (Fletcher-Munson corrected) but a truly flat impulse response (actually the top end rolls off gently ABOVE 16khz). -- Phil Leigh You want to see the signal path BEFORE it gets onto a CD/vinyl...it ain't what you'd call minimal... Touch(wired/W7)+Teddy Pardo PSU - Audiolense 3.3/2.0+INGUZ DRC - MF M1 DAC - Linn 5103 - full Aktiv 5.1 system (6x LK140's, ESPEK/TRIKAN/KATAN/SEIZMIK 10.5), Pekin Tuner, Townsend Supertweeters,VdH Toslink,Kimber 8TC Speaker & Chord Signature Plus Interconnect cables Stax4070+SRM7/II phones Kitchen Boom, Outdoors: SB Radio, Harmony One remote for everything. ------------------------------------------------------------------------ Phil Leigh's Profile: http://forums.slimdevices.com/member.php?userid=85 View this thread: http://forums.slimdevices.com/showthread.php?t=93317 _______________________________________________ audiophiles mailing list audiophiles@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/audiophiles