Hi Patrick, With the package i made yesterday, "pxafb" module was NOT automatically loaded at boot time. So, login via USB or serial cable was mandatory in order to manually "modprobe" frame buffer...
Here is an updated version : http://jn.graux.free.fr/x51v-linux/x51v-linux.tar.gz I also did some modification in initrd.gz to speed up the boot. Be careful, using NFS for root file system is no longer possible with this release. Patrick Steiner <patrick.steiner <at> a1.net> writes: > > I have successfully build (not testet) a angstrom > (http://www.angstrom-distribution.org/) axim image via openembedded. > > now i´ll try to include all the patches to the hh kernel. if this works. > i´ll try to add the axim x51v to OE. > > meanwhile i have bootet my axim with linux from > http://jn.graux.free.fr/x51v-linux/ (version from yesterday). > > i get the usb-device on host, but i always get the following error: > > usb 2-2: new full speed USB device using uhci_hcd and address 16 > usb 2-2: configuration #1 chosen from 1 choice > usb0: register 'cdc_subset' at usb-0000:00:1d.1-2, Linux Device, > e2:d8:ec:8a:bd:48 > NETDEV WATCHDOG: usb0: transmit timed out > usb0: no IPv6 routers present > NETDEV WATCHDOG: usb0: transmit timed out > NETDEV WATCHDOG: usb0: transmit timed out > NETDEV WATCHDOG: usb0: transmit timed out If you got this, this probably means that Haret failed to load Linux... > > and is also doesnt see anything on my axim. if i activate the mirror > mode i see a big-fat black-bar on my screen after a few seconds. > Yep ... This means that Haret failed to load linux... > without mirror mode i see the 4 colored lines. this should be right or? > Without mirror mode enabled, you MUST see five horizontal colored lines (blue, red, light blue, yellow, black). If so, this means that Linux was successfully loaded. > btw. i have got a german axim x51v with the latest german rom on it. > > patrick > Before booting Linux, make sure that : - ONLY Haret is running (close all other applications) - rootfs image must be in the root of your SD card. To log-on using telnet over USB, wait for one minute after boot and unplug / plug Axim from cradle. Then, do "lsusb" to check that usb device has been detected by your HOST. Finally, "telnet 10.0.0.2" and login using "root" as login and "x50v-linux" as password... Do not hesitate to try several telnet ..... Bye -- _______________________________________________ Aximx50-port mailing list [email protected] https://www.handhelds.org/mailman/listinfo/aximx50-port
