Am Fri, 11 Jun 2010 22:36:47 -0300 schrieb Daniel Bareiro: > Hi all! > > I'm doing tests with a brand new HP Storageworks 1/8 G2 I plan to use > with Bacula on Debian GNU/Linux Lenny. > > The tape autoloader is connected to a PC through an HP Smart Array P212 > card. It is HP's entry level PCI Express Serial Attached SCSI RAID > controller. > > In these initial tests I intend to make the autoloader and the drive to > recognize commands sent using mtx and mt, respectively. > > However, in the operating system I'm only seeing the tape drive, but not > the autochanger: > > > backup:~# cat /proc/scsi/scsi > Attached devices: > Host: scsi3 Channel: 00 Id: 00 Lun: 00 > Vendor: ATA Model: ST3160211AS Rev: 3.AA Type: > Direct-Access ANSI SCSI revision: 05 > > > But I'm not seeing a /dev/st0 or /dev/nst0 device.
did you try backports kernel 2.6.32 ? (www.backports.org) - Thomas ------------------------------------------------------------------------------ ThinkGeek and WIRED's GeekDad team up for the Ultimate GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the lucky parental unit. See the prize list and enter to win: http://p.sf.net/sfu/thinkgeek-promo _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
