Hello there, I have been working on a robotics project using the beaglebone black and have just run into some difficulty.
I am using a protocape for holding all of my circuitry to various sensors. While the protoboard is connected, the board turns on but does not boot. When I disconnect the protocape, my board turns on and boots normally. This happened in between runs with no changes made. I have changed batteries, disconnected different sensors, and do not have my robotics routine running on start up. That is the extent of my troubleshooting skills. Does anyone have any suggestions on what else to check? I don't know how this could have happened with no changes made, but alas, this is what happens two weeks before a project is due. Thank you in advance -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.