On Monday, April 6, 2015 at 2:32:55 PM UTC-4, star...@gmail.com wrote: > > Hello there, I have been working on a robotics project using the > beaglebone black and have just run into some difficulty. > > I am using a protocape for holding all of my circuitry to various sensors. > While the protoboard is connected, the board turns on but does not boot. > When I disconnect the protocape, my board turns on and boots normally. This > happened in between runs with no changes made. >
Sounds to me like you're shorting something on your protocape. Check your pin usage, particularly the power/gnd pins. Also look for shorts on the protoboard (again, pwr/gnd lines), I know it's easy to make mistakes on the protoboards. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.
