On 11/6/05, Dan McGhee <[EMAIL PROTECTED]> wrote: > Situation 1: > > After using tzselect and following the instructions my timezone is > 'America/Chicago.' The command says 'cp --remove-destination > /usr/share/zoneinfo/$TIMEZONE /etc/localtime' I typed it directly and > then noticed--much later--that the results of tzselect were referred to > as $TIMEZONE. So should the command I typed have been ' cp > --remove-destination /usr/share/zoneinfo/America/Chicago /etc/localtime'?
Definitely a typo. It should be $TZ and that would result in the last line you wrote. > Situation 2: > > After modifying /etc/rc.d/init.d/setclock, the instructions say to add > the symlinks > > # ln -s ../init.d/setclock /etc/rc.d/rc0.d/K45setclock && > # ln -s ../init.d/setclock /etc/rc.d/rc6.d/K45setclock > > Each of these symlinks contain 'K45setclock' I can't remember if the > K45 refers to a priority or run levels. In rc0.d and rc6.d I already > have K45random. Should I change the links to K4?setclock (where ? > refers to a number less than or greater than 5)? Everything in the name (besides the S or K) is just for ordering since the script running them is going through alphabetically (or lexically or whatever that word is). So the scripts needed to run first have lower numbers. It's OK to have scripts with the same numbers. You could change the number if you're certain you want it before or after random, but it probably isn't important. I have K30dbus and K30sshd and haven't had an issue with that. -- Dan -- http://linuxfromscratch.org/mailman/listinfo/blfs-support FAQ: http://www.linuxfromscratch.org/blfs/faq.html Unsubscribe: See the above information page
