You'd have the advantage if it were for the alcohol classes. Can't see methanol burning anyway. ----- Original Message ----- From: Larry Stansifer To: blindhandyman@yahoogroups.com Sent: Monday, December 01, 2008 7:20 PM Subject: RE: [BlindHandyMan] Using fire extinguishers as a bat
The co-2 extinguishers will also work well for freezing ground hornet nests. About two years ago I went through a fire suppression course and the fire department had a large round metal pan that they would partially fill with water and pore gasoline over the surface. They would ignite the fuel and I got to nock down the resulting fire. Pretty strait foreword if you don't let the fire rattle you. I also read where NHRA does fire simulation training for the top fuel and top alcohol dragsters and funny car drivers. -----Original Message----- From: blindhandyman@yahoogroups.com [mailto:[EMAIL PROTECTED] On Behalf Of Bob Kennedy Sent: Monday, December 01, 2008 4:35 PM To: blindhandyman@yahoogroups.com Subject: Re: [BlindHandyMan] Using fire extinguishers as a bat I've done that pouter trick too I just figured I was the only one and didn't want a bunch of extra emails coming in telling me I was crazy or sick. That's never been in question... ----- Original Message ----- From: Bill Stephan To: blindhandyman@yahoogroups.com Sent: Monday, December 01, 2008 6:21 PM Subject: Re: [BlindHandyMan] Using fire extinguishers as a bat I used one of the dry powder extinguishers on a guy who was going to hold up a store I ran once when I was younger, and it really changed his mind in a hurry. We also used to recommend using the Co2 type for getting tyle or carpet glue off concrete floors, it freezes and sort of chips off sometimes. Bill Stephan, Kansas City MO Email: [EMAIL PROTECTED] Phone: (816)803-2469 -original message- Subject: Re: [BlindHandyMan] Using fire extinguishers as a bat From: Bob Kennedy <[EMAIL PROTECTED]> Date: 12/01/2008 15:27 I've had to do this before under what could be called real shop situations... CO2 extinguishers are good for bringing the temp of oil or grease fires down as long as you feather the trigger when squeezing it. Full force you can spread the fire farther. And remember not to get your fingers or hand in front of the tube as you spray it. That is nasty cold stuff and it will do some serious damage to you if you blast your skin. I've seen a fire company use it to kill a snake before, so it's good for more than fires... If you use dry chemical, it will put out a cloud too and it will make breathing very rough for a while. But losing a house or shop is even worse than breathing trouble. I've lost one to fire before but an extinguisher wouldn't have helped at all in that case. ----- Original Message ----- From: Tom Fowle To: blindHandyMan Sent: Monday, December 01, 2008 3:23 PM Subject: [BlindHandyMan] Using fire extinguishers as a bat Hi all. this may be old hat to some of you experienced folks, but I found the following interesting. I'd always wanted to really try using an extinguisher on a "real" fire. I wanted to have some idea if I might stand a chance of doing usefull fire fighting if i drop my soldering iron on a pile of paper or some such. However I didn't want to set up a test without professional help just in case things should get out of hand. I found that a niece's new boy friend is a professional fire fighter. When I met Joe last year, almost the first thing I asked him after a little introductory chatter was whether he might set up a test fire somewhere and suggest an extinguisher for me to try. This was a year ago and I' hadn't seen Joe since. This thanksgiving, we went to my brother's 5 acre place in the country and Joe was there. I hadn't mentioned my request over the year and figured if he was interested, he'd bring it up. I wasn't going to ask again. Almost the first thing i heard was " Tom I've got an extinguisher for you." So, Friday afternoon, we went out to the middle of a gravel coverred area and Joe got hold of an old cardboard box and a heap of waiste paper. He really wanted to add a mix of gasoline and diesel, but everyone else thought that was going a bit far. He had an out of date "dry chemical" extinguisher, the type with a pair of handles you squeeze together and a 1 foot hose you aim at the fire. After the fire was going well enough I could readilly feel it from a few feet away, I held the extinguisher in my left hand, and followed his instructions. they suggest a memory trick using "PASS" Pull, Aim, Squeeze Sweep. Pull, means pull the safety pin, a rod with a circular ring at one end that goes through the top handle of the extinguisher and keeps it from being squeezed down when not in use. Aim, of course means take the end of the little hose and aim it at the base of the fire. Squeeze, press the two handles together. Sweep, means sweep the stream of chemical back and forth across the fire. My experience suggests that moving in a flattened oval so the stream moves "up and down" a bit as well as across where you think the fire is, may be a good bet if you can't see the flames at all. Not surprisingly, I had little trouble knocking this relatively minor fire down. Joe had me stop firing several times while he stirred up the fire again to give me several tries. I did have the tendency to knock over the box with the stream of chemical, but this would probably not happen in a more real world situation. One might think about whether you might blow burning material away and spread a fire with a strong stream of stuff. This would further encourage me to believe in the vertical oval movement strategy. In a real fire situation, you don't stop spraying your extinguisher's contents till the thing is empty. Even if you're pretty sure the fire is out, the policy is to empty the device just to be sure. Of course any test like this can't be totally real,, it was controlled and I knew what was going to be burned and where. And, of course I wasn't in a panic. However I believe I at least found i may be able to knock down a fire to the extent that I should consider trying an extinguisher if one is available. Of course there a lot of other strategies to fire fighting depending on what's burning, E.G. if it's a grease fire in a pan, just putting a lid on the pan may be enough to do the job. |Dryy chemical extinguishers are good for most fires, the disadvantage of these types is that they leave a powdery mess over everything. [CO2 carbondioxide extinguishers are good for most fires but of course do realease a quantity of co2 into the atmosphere. I don't know of other disadvantages of this type. There are pressurized water units but they should never be used on electrical, grease or flamable liquid fires, so probably aren't a good bet. Hailon is expensive, as are it's new substitutes, and are good for almost all fires, but one must be carefull to get out of the way of the cloud of gas since it makes breathing impossible. I'd suggest, if you work with anything that might go wrong and cause a fire, that you may want to meet a friendly fireman and set up a similar test for your selves just so you'll have a feel for how it all goes. Everyone with a home containing a kitchen should have, and maintain, an appropriate extinguisher where you can get at it. Contact your local fire fighters to find out what local code says is appropriate for you. Of course if you have a fire, whether you try fighting it your self or not, call the local fire department. Even if you think it's out, you want professional help to be sure there is no way it could spread and something you didn't catch is still going. Hope this encourages you to try something for your selves and learn more about what you can do. Besides, since I had a pro on hand, it was fun and helped build a good connection with a possible future family member. tom Fowle [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] ------------------------------------ Send any questions regarding list management to: [EMAIL PROTECTED] To listen to the show archives go to link http://www.acbradio.org/pweb/index.php?module=pagemaster&PAG E_user_op=view_page&PAGE_id=33&MMN_position=47:29 Or ftp://ftp.acbradio.org/acbradio-archives/handyman/ The Pod Cast address for the Blind Handy Man Show is. http://www.acbradio.org/news/xml/podcast.php?pgm=saturday Visit The Blind Handy Man Files Page To Review Contributions From Various List Members At The Following address: http://www.jaws-users.com/JAWS/handyman/ Visit the archives page at the following address http://www.mail-archive.com/blindhandyman@yahoogroups.com/ If you would like to join the JAWS Users List, then visit the following address for more information: http://www.jaws-users.com/ For a complete list of email commands pertaining to the Blind Handy Man list just send a blank message to: [EMAIL PROTECTED] Groups Links -- BEGIN-ANTISPAM-VOTING-LINKS ------------------------------------------------------ Teach InfoWest Spam Trap if this mail (ID 227181487) is spam: Spam: https://spamtrap.infowest.com/canit/b.php?i=227181487&m=1fe8 e74e89c8&c=s Not spam: https://spamtrap.infowest.com/canit/b.php?i=227181487&m=1fe8 e74e89c8&c=n Forget vote: https://spamtrap.infowest.com/canit/b.php?i=227181487&m=1fe8 e74e89c8&c=f REMEMBER: Never give out your account information, password, or other personal information over e-mail. ------------------------------------------------------ END-ANTISPAM-VOTING-LINKS [Non-text portions of this message have been removed]
