Configure the VLANs on your switch/router. Enable VLAN on the AP and
configure for your environment/prefs.
Configure NAT mode on the SM. Set default port VID on the VLAN config
page. The SM's NAT WAN interface will be on that VLAN on the RF side and
come out of the AP's ethernet interface tagged.
On 7/21/2017 1:26 PM, Ethan E. Dee wrote:
Is there a way to put a VLAN interface on the WLAN side of a PMP450i
900mhz? And then nat through the radio so that LAN port hands off a
private IP? Played around with it about an hour and couldn't get it.
Obviously missing something.
--
Ethan Dee
Network Admin
Globalvision
864 704 3600
e...@globalvision.net
For Support:
gv-supp...@globalvision.net
864 467 1333
For Sales:
sa...@globalvision.net
864 467 1333
--
This message has been scanned for viruses and dangerous content by
*E.F.A. Project* <http://www.efa-project.org>, and is believed to be
clean.
_______________________________________________
Cambium-users mailing list
Cambium-users@wispa.org
http://lists.wispa.org/mailman/listinfo/cambium-users
_______________________________________________
Cambium-users mailing list
Cambium-users@wispa.org
http://lists.wispa.org/mailman/listinfo/cambium-users
