sorry if this is a repeat; fighting email troubles today.
from https://casper.berkeley.edu/wiki/ROACH-2_Revision_2#Schematics are Roach2 rev2 https://github.com/ska-sa/roach2_hardware/blob/master/release/rev2/A/ASSEMBLY/roach2_rev2_schematics.pdf?raw=true from https://casper.berkeley.edu/wiki/ROACH2#Schematics Roach2 rev 1 https://casper.berkeley.edu/wiki/images/a/a5/Roach2_rev1_schematics.pdf Matt PS. the ADC16 wiki pages have all sorts of files on ZDok+ pin changes which we've found to be helpful. for example: https://casper.berkeley.edu/wiki/ADC16x250-8_differential_rev_2#ADC16x250-8_differential_rev_2_Block_Diagram_and_pin_mappings or more specifically https://casper.berkeley.edu/wiki/images/6/6e/ZDok_pins_diff_rev2_2013apr24.pdf https://casper.berkeley.edu/wiki/images/2/2d/Host_clock_pins_2013feb05.txt On Thu, 9 May 2013, Kim Guzzino wrote:
Date: Thu, 9 May 2013 08:34:06 -0700 From: Kim Guzzino <kguzz...@hawaii.edu> To: 'Henno Kriel' <he...@ska.ac.za> Cc: 'casper' <casper@lists.berkeley.edu> Subject: Re: [casper] Roach2 Rev2 Pinouts Thanks Henno. That is the repo I was using. There are some differences with the commented out adc pins in the UCF and the mat file, but I guess they don’t matter much. But, there IS a difference in the schematic to the hw-route file. DP 18 swapped with 28 and 19 swapped with 29. Is the schematic of the rev 1 and rev2 on the casper site correct? Thanks for the reply Kim From: Henno Kriel [mailto:he...@ska.ac.za] Sent: Wednesday, May 08, 2013 9:33 PM To: KimGuzzino Subject: Re: [casper] Roach2 Rev2 Pinouts Hi Kim Just check your hw_routes.mat & ucf file with the SKA-SA repo - there was changes to the ZDOK routing on Rev2. Regards Henno On Wed, May 8, 2013 at 10:03 PM, KimGuzzino <kguzz...@hawaii.edu> wrote: Dear Casperites, I was having problems with the pin mappings for the Roach2 Rev 2 using ZDOK pair declarations in my yellow block xps_10gadc.m file. I requested one to use pair 18 and it mapped to 28.( both ZDOKS) and maps to 28 and 29 a appear on 18 and 19 respectively. I looked at the hw_routes.mat file and it looks correct. I had to put the pinouts in my gen_ucf.m file. Has anyone seen such a problem? I am using 2009b , 14.4 and mlib_devel-master that I pulled last week from github. Kim -- Henno Kriel DSP Engineer Digital Back End meerKAT SKA South Africa Third Floor The Park Park Road (off Alexandra Road) Pinelands 7405 Western Cape South Africa Latitude: -33.94329 (South); Longitude: 18.48945 (East). (p) +27 (0)21 506 7300 (p) +27 (0)21 506 7365 (direct) (f) +27 (0)21 506 7375 (m) +27 (0)84 504 5050