Is the design and lab setup consistent with the limitations documented at https://casper.berkeley.edu/wiki/ADC16x250-8#ADC16_Sample_Rate_vs_Virtex-6_MMCM_Limitations ?
More information on the clock requirements may be found at https://casper.berkeley.edu/wiki/ADC16x250-8_coax_rev_2#ADC16x250-8_coax_rev_2_Inputs Matt On Wed, 29 Mar 2017, vijay kumar wrote:
Date: Wed, 29 Mar 2017 17:16:34 -0400 From: vijay kumar <[email protected]> To: [email protected] Subject: [casper] ADC calibration issue Hello Casperites, I have been working on the ROACH-2 casper for the past few months. Now i have started to capture values from the ADC 16x250-8 block. But, when I am trying to run the initialization script, it gives me an error saying that "chip 'x' chan 'x' lane 'x' no good taps found ". I am unable to figure out what might be causing this error. I would be glad if I could get help from you guys. Thank you. With regards Vijay -- You received this message because you are subscribed to the Google Groups "[email protected]" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected].
-- You received this message because you are subscribed to the Google Groups "[email protected]" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected].

