Hi Xavier,

One obvious question is do you really have just one ADC board?  Or have you 
seen the same results on more than one hardware set?

Also, where you say: "I adapted the CASPER design to match my hardware . . .” 
could you give a little more detail on what hardware you are using?  Is this 
based on a ROACH2?

Thanks,

Jonathan


> On Jul 27, 2017, at 8:02 PM, Xavier Bosch <[email protected]> wrote:
> 
> Hi all, 
> 
> I got a ADC 5G V2.0 DMUX1:1 and I decided to evaluate its performance. As 
> expected the results are poor and its phase needs to be calibrated. I read 
> the document in here 
> http://www.worldscientific.com/doi/pdf/10.1142/S2251171714500019 
> <http://www.worldscientific.com/doi/pdf/10.1142/S2251171714500019>  and I got 
> code from here  https://github.com/sma-wideband/adc_tests 
> <https://github.com/sma-wideband/adc_tests> I adapted the CASPER design to 
> match my hardware and I also adapted the calibration routines. 
> 
> The result is always the same: while setting the ADC in test mode, channels 
> a, b, c report 0 glitches while the channel d reports about ~2000 out of the 
> 16384 samples each time. I sweep the phase using the calibrate_mmcm_phase() 
> function but I never got to reduce the number of glitches.So the optimal 
> phase does not exist, hence it cannot be calibrated. 
> 
> I am attaching two histograms for ADC_fs=2,5GHz and a signal of input power 
> fo -10 dBm and 1 MHz and 800 MHz respectively. As you can see, a,b,c channels 
> are withing a reasonable margin while channel d gets out of control. 
> 
> Has anyone find a problem like that before? How have you solved? Is there 
> more available documentation for that part ?
> 
> Thank you, 
> 
> XB
> 
> 
> -- 
> You received this message because you are subscribed to the Google Groups 
> "[email protected]" group.
> To unsubscribe from this group and stop receiving emails from it, send an 
> email to [email protected] 
> <mailto:[email protected]>.
> To post to this group, send email to [email protected] 
> <mailto:[email protected]>.
> <HistogramTest_800MHz_m10dBm_sampling2p5GHz.png><HistogramTest_1MHz_m10dBm_sampling2p5GHz.png>

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to