Bob, I have an 86 model, what I call a Mk II, so it may not be the same. The
wire runs down the port side of the pulpit down thru a hole in the deck. Yours
is probably full of sealant. You will probably have to take the pulpit off or
at least loose to pull the wires out. I installed a deck plate in the anchor
well to access the nuts on the port cleat. There is no other way that I know
of to reach them. The bonus is that now I can reach back in there and grab the
light wires. That might be an easier way to get to yours.
Don, #6293, Niceville, FL
[EMAIL PROTECTED] wrote:
Listees,
On my 1984 the nav light sits in front of the pulpit. Has anyone replaced the
nav light wiring running thru the bow and stern pulpits? I have removed the
wood veneer in the bow just in front of the anchor locker. I have corrosion
where the RED/Black wiring meets the duplex wiring which runs thru the pulpit
to the nav lights.
I have cut the wiring at the RED/BLACK - Duplex butt connectors in order to
replace the duplex wiring ( which I have already purchased).
My question is: I can not budge the old pulpit/duplex wiring in either
direction. I have tugged, pulled and pushed the pulpit wiring from both sides (
outside the pulpit at the nav light and also from inside from the anchor locker
area. No Luck
I think the opening in the pulpit where the light sits is just too small to
pull or push this wire through.
Any sugggestions????????
Bob "Eileen" 1984 #5641
---------------------------------
Never miss a thing. Make Yahoo your homepage.
