Going through WB3 lab6 and the ipv6 tasks required using eigrp on cat 2 -
3560 12.2(25). It only appears to support ripng and ospfv3. OS issue?
Cat2(config)#ipv6 router ?
ospf Open Shortest Path First (OSPF)
rip IPv6 Routing Information Protocol (RIPv6)
Cat2(config)#ipv6 ?
access-list Configure access lists
cef Cisco Express Forwarding for IPv6
hop-limit Configure hop count limit
host Configure static hostnames
icmp Configure ICMP parameters
mld Global MLD Snooping enable for Catalyst Vlans
neighbor Neighbor
ospf OSPF
prefix-list Build a prefix list
route Configure static routes
router Enable an IPV6 routing process
unicast-routing Enable unicast routing
Cat2(config)#int vlan 90
Cat2(config-if)#ipv6 ?
IPv6 interface subcommands:
address Configure IPv6 address on interface
cef Cisco Express Forwarding for IPv6
enable Enable IPv6 on interface
nd IPv6 interface Neighbor Discovery subcommands
ospf OSPF interface commands
redirects Enable sending of ICMP Redirect messages
rip Configure RIP routing protocol
traffic-filter Access control list for packets
unnumbered Preferred interface for source address selection
Thanks,
Brian Barltrop
VCU Health Systems
Network Analyst
804-828-6130
NOTE: The information contained in this message may be privileged and
confidential and protected from disclosure. If the reader of this message
is not the intended recipient, you are hereby notified that any
dissemination, distribution or copying of this communication is strictly
prohibited. If you have received this communication in error, please
notify us immediately by replying to the message and deleting it from your
computer.
--------------------------------------
VCU Health System
http://www.vcuhealth.org
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
