Out of curiosity would you choose that exact version of 3560 code for production deployments or is that just a stable version of code with the particular features needed. Cisco doesn't offer safe harbor code releases for the lower series routers and switches so its a struggle to find the most stable release.
Thanks, Jason On Dec 30, 2009, at 1:37 PM, Tyson Scott wrote: > Brian, > > All the 3560's should be running 12.2(46)SE. If it is not and it is one of > our racks please let us know. > > Regards, > > Tyson Scott - CCIE #13513 R&S, Security, and SP > Technical Instructor - IPexpert, Inc. > Mailto: [email protected] > Telephone: +1.810.326.1444, ext. 208 > Live Assistance, Please visit: www.ipexpert.com/chat > eFax: +1.810.454.0130 > > IPexpert is a premier provider of Classroom and Self-Study Cisco CCNA (R&S, > Voice & Security), CCNP, CCVP, CCSP and CCIE (R&S, Voice, Security & Service > Provider) Certification Training with locations throughout the United States, > Europe and Australia. Be sure to check out our online communities at > www.ipexpert.com/communities and our public website at www.ipexpert.com > > From: [email protected] > [mailto:[email protected]] On Behalf Of Brian Barltrop > Sent: Wednesday, December 30, 2009 2:41 PM > To: [email protected] > Subject: [OSL | CCIE_RS] catalyst support for eigrpv6 > > > Going through WB3 lab6 and the ipv6 tasks required using eigrp on cat 2 - > 3560 12.2(25). It only appears to support ripng and ospfv3. OS issue? > > Cat2(config)#ipv6 router ? > ospf Open Shortest Path First (OSPF) > rip IPv6 Routing Information Protocol (RIPv6) > > Cat2(config)#ipv6 ? > access-list Configure access lists > cef Cisco Express Forwarding for IPv6 > hop-limit Configure hop count limit > host Configure static hostnames > icmp Configure ICMP parameters > mld Global MLD Snooping enable for Catalyst Vlans > neighbor Neighbor > ospf OSPF > prefix-list Build a prefix list > route Configure static routes > router Enable an IPV6 routing process > unicast-routing Enable unicast routing > > Cat2(config)#int vlan 90 > Cat2(config-if)#ipv6 ? > IPv6 interface subcommands: > address Configure IPv6 address on interface > cef Cisco Express Forwarding for IPv6 > enable Enable IPv6 on interface > nd IPv6 interface Neighbor Discovery subcommands > ospf OSPF interface commands > redirects Enable sending of ICMP Redirect messages > rip Configure RIP routing protocol > traffic-filter Access control list for packets > unnumbered Preferred interface for source address selection > > > Thanks, > > Brian Barltrop > VCU Health Systems > Network Analyst > 804-828-6130 > NOTE: The information contained in this message may be privileged and > confidential and protected from disclosure. If the reader of this message is > not the intended recipient, you are hereby notified that any dissemination, > distribution or copying of this communication is strictly prohibited. If you > have received this communication in error, please notify us immediately by > replying to the message and deleting it from your computer. > -------------------------------------- > VCU Health System > http://www.vcuhealth.org > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
