R2(config)#do sh run | s Serial0/1/0 interface Serial0/1/0 description Frame Relay Links ip address 150.100.100.2 255.255.255.0 encapsulation frame-relay frame-relay map ip 150.100.100.2 205 frame-relay map ip 150.100.100.6 206 broadcast frame-relay map ip 150.100.100.5 205 broadcast no frame-relay inverse-arp interface Serial0/1/0.1 point-to-point ip address 150.100.24.2 255.255.255.0
frame-relay interface-dlci # From: Amer Mustafa [mailto:[email protected]] Sent: September-01-10 5:52 PM To: Jason Maynard Cc: [email protected] Subject: Re: [OSL | CCIE_RS] Workbook 1 , LAB6 (Frame-Relay). Nope, its not working. R4(config-if)#do show fram map Serial0/0/0 (up): ip 150.100.100.2 dlci 412 (0x19C,0x64C0), dynamic, broadcast,, status defined, active R4(config-if)#do sh run | s Serial0/0/0 interface Serial0/0/0 ip address 150.100.24.4 255.255.255.0 encapsulation frame-relay frame-relay interface-dlci 412 R4(config-if)#do ping 150.100.24.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 150.100.24.2, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) R4(config-if)# On Thu, Sep 2, 2010 at 12:44 AM, Jason Maynard <[email protected]> wrote: Do sh "show frame map" to see that you are missing IP to DLCI mappings Add "frame-relay interface-dlci #" command From: [email protected] [mailto:[email protected]] On Behalf Of Amer Mustafa Sent: September-01-10 5:41 PM To: [email protected] Subject: [OSL | CCIE_RS] Workbook 1 , LAB6 (Frame-Relay). I am on task 6.4 for LAB 6 WB1. on R4 : R4#show run | s Serial0/0/0 interface Serial0/0/0 ip address 150.100.24.4 255.255.255.0 encapsulation frame-relay R4#ping 150.100.24.4 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 150.100.24.4, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) on R2 : R2(config)#do sh run | s Serial0/1/0 interface Serial0/1/0 description Frame Relay Links ip address 150.100.100.2 255.255.255.0 encapsulation frame-relay frame-relay map ip 150.100.100.2 205 frame-relay map ip 150.100.100.6 206 broadcast frame-relay map ip 150.100.100.5 205 broadcast no frame-relay inverse-arp interface Serial0/1/0.1 point-to-point ip address 150.100.24.2 255.255.255.0 R2(config)#do ping 150.100.24.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 150.100.24.2, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) R2(config)# what could be the reason ? ====================== regards ... Amer
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
