Got you jason, you are right, the topology table is showing the two routes
so obviosly there unequal cost load balancing was not enabled.

On Sun, Sep 5, 2010 at 2:39 AM, Jason Maynard <[email protected]>wrote:

>  Out of curiosity what does  “show ip eigrp topology 100.100.100.0”
> display
>
>
>
> *From:* [email protected] [mailto:
> [email protected]] *On Behalf Of *Amer Mustafa
> *Sent:* September-04-10 6:49 PM
> *To:* [email protected]
> *Subject:* [Bulk] [OSL | CCIE_RS] TASK : 9.6 (EIGRP) - LAB-9.
>
>
>
> *TASK : 9.6 (EIGRP) - LAB-9.*
>
>
>
> *Though i have complete and correct neighborship on R5:*
>
>
>
>
> ---------------------------------------------------------------------------------------------
>
> R5(config)#do show ip eigrp ne
> IP-EIGRP neighbors for process 1001
> H   Address                 Interface       Hold Uptime   SRTT   RTO  Q
> Seq
>                                             (sec)         (ms)       Cnt
> Num
> 3   150.100.220.7           Fa0/0             10 01:25:54    6   200  0  53
> 2   150.100.221.7           Fa0/1             11 01:25:54    6   200  0  52
> 1   150.100.100.2           Se0/1/0          162 01:37:56   85  2280  0  49
> 0   150.100.25.2            Se0/2/0           13 01:37:57    1  1140  0  48
>
>
> ---------------------------------------------------------------------------------------------
>
>
>
> *Still when giving : show ip route 100.100.100.0 , i can see it only
> through 150.100.25.2, but the workbook states that it should come through
> both 150.100.25.2 and 150.100.100.2. *
>
> *R5#SHOW IP ROUTE 100.100.100.0**
> Routing entry for 100.100.100.0/24
>   Known via "eigrp 1001", distance 90, metric 20517120, type internal
>   Redistributing via eigrp 1001
>   Last update from 150.100.25.2 on Serial0/2/0, 00:49:06 ago
>   Routing Descriptor Blocks:
>   * 150.100.25.2, from 150.100.25.2, 00:49:06 ago, via Serial0/2/0
>       Route metric is 20517120, traffic share count is 1
>       Total delay is 20200 microseconds, minimum bandwidth is 128 Kbit
>       Reliability 255/255, minimum MTU 1500 bytes
>       Loading 1/255, Hops 2*
>
>
>
>
>
>
>
> *Please advise. *
>
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit 
www.ipexpert.com

Reply via email to