Please get in touch with our support if you think there is a hardware issue. I included them in CC here.
-- Marko Milivojevic - CCIE #18427 Senior Technical Instructor - IPexpert Free CCIE Training: http://bit.ly/vLecture Mailto: [email protected] Telephone: +1.810.326.1444 Community: http://www.ipexpert.com/communities :: Sent from my phone. Apologies for errors and brevity. :: On Nov 7, 2010, at 23:17, Ramcharan Arya <[email protected]> wrote: > Hi, > > I have load initial configuration on R2 and R5 . Serial 0/2/0 interface on R2 > showing standby mode and line protocol is down > On R5 it is showing down/down > > > Configuration on R5: > R5#sh run int se0/2/0 > Building configuration... > Current configuration : 102 bytes > ! > interface Serial0/2/0 > bandwidth 128 > ip address 150.100.25.5 255.255.255.0 > encapsulation ppp > end > > > R5#sh int se0/2/0 > Serial0/2/0 is down, line protocol is down > Hardware is GT96K Serial > Internet address is 150.100.25.5/24 > MTU 1500 bytes, BW 128 Kbit/sec, DLY 20000 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation PPP, LCP Closed, loopback not set > Keepalive set (10 sec) > CRC checking enabled > Last input 00:15:54, output 00:15:54, output hang never > Last clearing of "show interface" counters 01:00:48 > Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: weighted fair > Output queue: 0/1000/64/0 (size/max total/threshold/drops) > Conversations 0/1/256 (active/max active/max total) > Reserved Conversations 0/0 (allocated/max allocated) > Available Bandwidth 96 kilobits/sec > 5 minute input rate 0 bits/sec, 0 packets/sec > 5 minute output rate 0 bits/sec, 0 packets/sec > 61 packets input, 2900 bytes, 0 no buffer > Received 0 broadcasts, 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort > 79 packets output, 3370 bytes, 0 underruns > 0 output errors, 0 collisions, 5 interface resets > 14 unknown protocol drops > 0 output buffer failures, 0 output buffers swapped out > 22 carrier transitions > DCD=down DSR=down DTR=up RTS=up CTS=down > R5# > > ----------------- > on R2: > interface Serial0/2/0 > description Serial Link to R5 > bandwidth 128 > ip address 150.100.25.2 255.255.255.0 > encapsulation ppp > clock rate 128000 > > > Is this part of troubleshooting of this lab.? Has anyone experience this > before.? Please let me know. > > BTW : I reload initial configuration twice on R2 and R5 still interface > shows down/down > > > Thanks & Regards, > Ram > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
