Hey OSL

Any comments?

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Jason Maynard
Sent: February-27-11 11:41 AM
To: [email protected]
Subject: [OSL | CCIE_RS] Vol1-Lab21.2

Quick question 

 

-          Configure traffic shaping for all traffic other than H.323 voice
destined for 200.0.0.4

-          Equal-cost paths to 200.0.0.4

-          Make sure traffic-shaping is enabled on both interfaces 

-          Bit rate allowed is 7Mbps (no excess-burst)

-          Path through f0/0 do not use traffic-shape

-          You may use 1 class-map but no “match protocol” or  “match
access-group” specifically

 

The DSG showed a solution using traffic-shape (f0/1) and MQC (f0/0

 

My solution is with MQC since it did not state that I had to use
traffic-shape command on either interface 

 

class-map match-all 21.2

match not protocol h323

match not access-group 100

policy-map P-21.2

class 21.2

    shape average 7000000 28000 0 ß How I got the 28000 was a warning comes
up from IOS stating “shape average 700000 ?

  WORD  bits per interval, sustained. Recommend not to configure it, the

        algorithm will find out the best value . 

 

I let IOS perform the calculation applied the policy-map, did a “show
policy-map interfas0/0”  and saw that IOS picked “7000000 28000 28000”,
since there is a requirement not to have BE I edited the shape average to
“7000000 28000 0”

 

access-list 100 permit ip any host 200.0.0.4

 

interface FastEthernet0/0

ip address 150.100.220.7 255.255.255.0

duplex auto

speed auto

service-policy output P-21.2

 

interface FastEthernet0/1

ip address 150.100.221.7 255.255.255.0

duplex auto

speed auto

service-policy output P-21.2

 

do sh policy-map inter fas 0/0

FastEthernet0/0 

 

  Service-policy output: P-21.2

 

    Class-map: 21.2 (match-all)

      196 packets, 21969 bytes

      5 minute offered rate 0 bps, drop rate 0 bps

      Match: not protocol h323

      Match: not access-group 100

      Queueing

      queue limit 64 packets

      (queue depth/total drops/no-buffer drops) 0/0/0

      (pkts output/bytes output) 196/20045

      shape (average) cir 7000000, bc 28000, be 0

      target shape rate 7000000

 

    Class-map: class-default (match-any)

      0 packets, 0 bytes

      5 minute offered rate 0 bps, drop rate 0 bps

      Match: any 

      

      queue limit 64 packets

      (queue depth/total drops/no-buffer drops) 0/0/0

      (pkts output/bytes output) 0/0

 

 

do sh policy-map inter fas 0/1

FastEthernet0/1 

 

  Service-policy output: P-21.2

 

    Class-map: 21.2 (match-all)

      157 packets, 15134 bytes

      5 minute offered rate 0 bps, drop rate 0 bps

      Match: not protocol h323

      Match: not access-group 100

      Queueing

      queue limit 64 packets

      (queue depth/total drops/no-buffer drops) 0/0/0

      (pkts output/bytes output) 157/15765

      shape (average) cir 7000000, bc 28000, be 0

      target shape rate 7000000

 

    Class-map: class-default (match-any)

      0 packets, 0 bytes

      5 minute offered rate 0 bps, drop rate 0 bps

      Match: any 

      

      queue limit 64 packets

      (queue depth/total drops/no-buffer drops) 0/0/0

      (pkts output/bytes output) 0/0

 

 

 

Let me know if you believe I would have got the points and all feedback is
appreciated (Please include ways that you would have answered the question
and explain why you went in the direction you did)

 

 

Thanks

 

Jason

_______________________________________________
For more information regarding industry leading CCIE Lab training, please
visit www.ipexpert.com

_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit 
www.ipexpert.com

Reply via email to