You'd put an ACL on IPv4 traffic if you don't want ALL IPv4 traffic to go into the queue you're configuring.
On Wed, Jun 15, 2011 at 11:48 AM, Alef <[email protected]> wrote: > So why put an ACL for normal ip traffic then ? > or you mean this only applies for ipv6 ? > > On Jun 15, 2011, at 4:46 PM, Jay Taylor wrote: > > Without calling an ACL all packets for that protocol are put into that > queue. > > On Wed, Jun 15, 2011 at 7:38 AM, Alef <[email protected]> wrote: > >> I noticed that with the priority queues, that ipv6 is not bound to a acl >> of permit any any? i.e. for all other traffic, the command is set as : >> priority-list 1 protocol ip low list 102 >> >> but ipv6 is done as: >> priority-list 1 protocol ipv6 normal >> >> with no acl? >> >> any clues ? >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >> > > > > -- > > Jay Taylor > CCIE #28391 > @JTIE_6EE7 > > > > -- Jay Taylor CCIE #28391 @JTIE_6EE7 _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
