Off the top of my head - Did you trust the DHCP server that I is connected to the switch? Or did you reload the routers?
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Cedric King Sent: August-06-11 11:19 PM To: [email protected] Subject: [OSL | CCIE_RS] L1v3task 2-4 I've been working on Task 2-4 Lab 1 workbook 3 for about two hours now and can not get the pppoe to come up between R6 - 7.. I have the following config a applied: r6 ------ bba-group pppoe group global interface virtual-temp 1 int virtual-temp 1 encap ppp ip addr x.x.67.6 255.255.255.0 ip mtu 1492 ip dhcp exclude-addr x.x.67.1 x.x.67.6 ip dhcp exclude-addr x.x.67.8 x.x.67.255 ip dhcp pool R67 network x.x.67.0 /24 int fa0/0 no ip addr pppoe enable group global R7 ---- int fa0/0 no ip addr pppoe-client dial-pool-number 1 int dialer 1 encap ppp ip mtu 1492 ip addr dhcp dialer pool 1 I've been through the solution guide and i've watched the video work book and have followed each step.. and its not working.. I've verified the physical set up of my devices and they are correct... Then I applied this setup to different devices in the lab and they worked.. they only thing different is dhcp snooping in enable in clan 67... If this is the cause. and I'm not saying it is... was this missed on purpose ? _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
