Maybe show policy-map interface command? Sent from G2
marc abel <[email protected]> wrote: Trying to do MQC based frame relay traffic shaping and not getting anywhere. What am I doing wrong? policy-map MQC-TS class class-default shape average 72000 ! interface Serial1/0 no ip address encapsulation frame-relay serial restart-delay 0 no frame-relay inverse-arp frame-relay lmi-type ansi ! interface Serial1/0.28 point-to-point ip address 10.20.28.27 255.255.255.0 snmp trap link-status frame-relay interface-dlci 708 class PVC-R27-R28 ! map-class frame-relay PVC-R27-R28 service-policy output MQC-TS R27(config)#do show traffic-shape R27(config)# _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs UHS Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited. If this was sent to you in error, please notify the sender by reply e-mail and destroy all copies of the original message. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
