can someone please help me to figure out the problem? I'm trying to apply
route-map in vlan interface on Cisco 3560G but its not functional neither i can
see it in show running while "sdm prefere routing+reboot" are already
accomplished! please let me know how can i apply route-maps in vlan
interfaces.I;m using both dynamic routing & inter-vlan routing on the unit.
show sdm prefer#
The current template is "desktop routing" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 3K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 11K
number of directly-connected IPv4 hosts: 3K
number of indirect IPv4 routes: 8K
number of IPv4 policy based routing aces: 0.5K
number of IPv4/MAC qos aces: 0.5K
number of IPv4/MAC security aces: 1K
Configuration:
(config)#interface vlanxx
(config-if)#ip policy route-map vlan-gateway
3560G#Show run | begin interface
Output:
interface VlanXX
description XX
ip address XXX.XXX.XXX.XX
ip helper-address XXX.XXX.XXX.XX
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
http://onlinestudylist.com/mailman/listinfo/ccie_rs
