Also Try "term Length 0" in enable mode, then show run. Was this preconfigured?
Sent from my iPhone On Mar 9, 2013, at 11:55 AM, Bob McCouch <[email protected]> wrote: > What privilege are you getting? What is the actual output you get when > you show run? > > Bob > -- > Sent from my iPhone, please excuse any typos. > > On Mar 9, 2013, at 11:49 AM, Chetan Thakkar <[email protected]> wrote: > >> Guys, >> >> Need some help, when I try to give command - sh run >> >> connected through Access swicth 2511 to Switches and routers I can only see >> only few lines on configuration. >> >> Configuration on Access Sw >> Line Vty 0 4 >> login >> transport input all >> transport output all >> >> Config on Switches >> >> line vty 0 4 >> login >> >> >> >> Telnet from my laptop to Access Switch and then telnet to Lab Switches and >> Router >> >> Eg of output - >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >> >> http://onlinestudylist.com/mailman/listinfo/ccie_rs > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
