Normally a priv 1 user cannot show run, but if the priv level on 'show run' was set down to 1 or even 0, you would see a very limited config when you 'show run' because as you mention you only see values you can change.
Bob -- Sent from my iPhone, please excuse any typos. On Mar 9, 2013, at 12:05 PM, Josh Miller <[email protected]> wrote: > I think its because they designed it to only show configurations the > logged in user is able to change. > > http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a00800949d5.shtml > > On Sat, Mar 9, 2013 at 9:07 PM, Chetan Thakkar <[email protected]> wrote: >> Guys, >> >> Need some help, when I try to give command - sh run >> >> connected through Access swicth 2511 to Switches and routers I can only see >> only few lines on configuration. >> >> Configuration on Access Sw >> Line Vty 0 4 >> login >> transport input all >> transport output all >> >> Config on Switches >> >> line vty 0 4 >> login >> >> >> >> Telnet from my laptop to Access Switch and then telnet to Lab Switches and >> Router >> >> Eg of output - >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >> >> http://onlinestudylist.com/mailman/listinfo/ccie_rs > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
