Hi Khaled, It seems that the sub-interface you have created is a point to point sub-interface (& not point-to-multipoint) In case of point to point interfaces you need to specify interface-dlci (& not MAP commands). As there is only device connected across the interface (POINT TO POINT - only 2 devices), only one DLCI is enough for all required communication (be it Ipv4 / IPv6 or any destination in IPv6 for that matter). Try following instead: R2(config-subif)#frame-relay interface-dlci 205 broadcast Hope this helps!
Regards, Naren ________________________________ From: khaled al-ajeman <[email protected]> To: [email protected] Sent: Thursday, 13 June 2013 1:47 PM Subject: [OSL | CCIE_RS] frame-relay switch hi there, I am trying to map the frame-relay link under point-to-point interface, but it is not allowing me to do that, any thought. However, at the Volume 1 SESSION it is workin fine, by the way I am using GNS. result R2(config-subif)#frame-relay map ipv fd00:0:0:6419::5 205 br Only frame-relay interface-dlci command should beused on point-to-point interfaces not frame-relay map thanks, khaled _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
