The problem was on Server side guys, i was using ip address under phisical interface and under virtual-template i was using ip unnumbered phisical_interface.
I put the ip address under virtual-template and ospf works fine. ;) -- Michel Perez Skype: michelmbperez [email protected] http://br.linkedin.com/in/michelmbperez 2014-05-14 18:25 GMT-03:00 Tony Singh <[email protected]>: > > > Does the DHCP broadcast reach the server in the debugs? > > Where's your DHCP configs on client/server at? > > No output, no help > > -- > BR > > Tony > > > > On 13 May 2014, at 17:57, marc abel <[email protected]> wrote: > > > > It's been a couple years since I explored this topic, but I do remember > > battling similar issues. Your experience is kind of backward from what I > > would expect, I would think the DHCP would work but the IPCP fail due to > > the /32 route. Have you tried experimenting with different OSPF area > types? > > > > Also fair warning, dealing with this stuff and IPv6 is even worse. I > think > > I finally swore it off and just prayed I didn't get IPv6 mixed with > PPPoE. > > > > > > On Tue, May 13, 2014 at 7:37 AM, Michel L. M. B. Perez < > > [email protected]> wrote: > > > >> Yes Marc, thanks for your help. I read this thread. > >> > >> The question for me is using DHCP no routes on Client Side, using POOL, > >> routes on Client Side. > >> > >> Just trying to understand. > >> > >> > >> > >> -- > >> Michel Perez > >> Skype: michelmbperez > >> [email protected] > >> http://br.linkedin.com/in/michelmbperez > >> > >> > >> 2014-05-13 9:14 GMT-03:00 marc abel <[email protected]>: > >> > >> > >>> See if this helps. > >>> > >>> https://learningnetwork.cisco.com/thread/6026 > >>> On May 12, 2014 11:33 PM, "Michel L. M. B. Perez" < > >>> [email protected]> wrote: > >>> > >>>> Hello guys, > >>>> > >>>> I have two routers R1 and R2, R1 is the PPPoE Server and R2 is the > >>>> client. > >>>> > >>>> My problem is, Ok, PPPoE works fine, R2 get IP Address, but OSPF is > not > >>>> working properly. > >>>> > >>>> I can see the ospf adjacency between the two routers, but the routes > >>>> does`t > >>>> seems to get installed into the RIB. > >>>> > >>>> Is it right? Cause if i use Pool OSPF works great, if I use pool > Dialer > >>>> on > >>>> Client side get mask /32 if i use DHCP client side gets /24. > >>>> > >>>> Any suggestion? > >>>> > >>>> Thanks. > >>>> -- > >>>> Michel Perez > >>>> Skype: michelmbperez > >>>> [email protected] > >>>> http://br.linkedin.com/in/michelmbperez > >>>> _______________________________________________ > >>>> Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos > :: > >>>> > >>>> iPexpert on YouTube: www.youtube.com/ipexpertinc > > > > > > -- > > Marc Abel > > CCIE #35470 > > (Routing and Switching) > > _______________________________________________ > > Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: > > > > iPexpert on YouTube: www.youtube.com/ipexpertinc > _______________________________________________ Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: iPexpert on YouTube: www.youtube.com/ipexpertinc
