I have had problems getting BACD to dial using voip from the phones on
CME. I can dial into the BACD fine from the PSTN, but not from my IP
phones. Here is my config:
voice service voip
allow-connections h323 to h323
dial-peer voice 3500 pots
service aa
incoming called-number 3500
port 0/2/0:23
!
dial-peer voice 3501 voip
destination-pattern 3500
session target ipv4:172.16.101.3
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 3502 voip
service aa
incoming called-number 3500
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
Eveytime I call the number I get "no circuit"
128A : 67 125333360ms.53 +-1 +3280 pid:20004 Answer 3004
dur 00:00:00 tx:0/0 rx:0/0 22 (no circuit (34))
Telephony 50/0/4 (67) [50/0/4.0] tx:0/0/0ms None noise:0dBm acom:0dBm
long duration call detected:n long dur callduration :n/a
timestamp:n/a128F : 71 125594800ms.54 +-1 +30 pid:3501 Originate 3500
dur 00:00:00 tx:0/0 rx:0/0 22 (no circuit (34))
IP 0.0.0.0:0 SRTP: off rtt:0ms pl:0/0ms lost:0/0/0 delay:0/0/0ms g729r8
pre-ietf TextRelay: off
media inactive detected:n media contrl rcvd:n/a timestamp:n/a
long duration call detected:n long dur callduration :n/a timestamp:n/a
