I always combine the voips.. dial-peer voice 3502 voip service aa destination-pattern 3500 incoming called-number 3500 dtmf-relay h245-alphanumeric codec g711ulaw no vad ip qos dscp cs3 sign
then prob need to do a call application voice load aa call application voice load acd What does your BACD commands look like and what are you trying to accomplist... drop through or _welcome_prompt? Thanks, Ryan Trauernicht On Tue, Jan 13, 2009 at 8:55 PM, Chris Parker <cpar...@cparker.us> wrote: > I have had problems getting BACD to dial using voip from the phones on CME. > I can dial into the BACD fine from the PSTN, but not from my IP phones. > Here is my config: > > voice service voip > allow-connections h323 to h323 > > dial-peer voice 3500 pots > service aa > incoming called-number 3500 > port 0/2/0:23 > ! > dial-peer voice 3501 voip > destination-pattern 3500 > session target ipv4:172.16.101.3 > dtmf-relay h245-alphanumeric > codec g711ulaw > no vad > ! > dial-peer voice 3502 voip > service aa > incoming called-number 3500 > dtmf-relay h245-alphanumeric > codec g711ulaw > no vad > > Eveytime I call the number I get "no circuit" > > 128A : 67 125333360ms.53 +-1 +3280 pid:20004 Answer 3004 > dur 00:00:00 tx:0/0 rx:0/0 22 (no circuit (34)) > Telephony 50/0/4 (67) [50/0/4.0] tx:0/0/0ms None noise:0dBm acom:0dBm > long duration call detected:n long dur callduration :n/a timestamp:n/a128F > : 71 125594800ms.54 +-1 +30 pid:3501 Originate 3500 > dur 00:00:00 tx:0/0 rx:0/0 22 (no circuit (34)) > IP 0.0.0.0:0 SRTP: off rtt:0ms pl:0/0ms lost:0/0/0 delay:0/0/0ms g729r8 > pre-ietf TextRelay: off > media inactive detected:n media contrl rcvd:n/a timestamp:n/a > long duration call detected:n long dur callduration :n/a timestamp:n/a > > >