Hi Chris: Is this router registered to a gatekeeper?.
Regards, Jose -----Original Message----- From: Chris Parker [mailto:cpar...@cparker.us] Sent: Tuesday, January 13, 2009 09:56 PM Eastern Standard Time To: ccie_voice@onlinestudylist.com Subject: [OSL | CCIE_Voice] BACD Voip peers I have had problems getting BACD to dial using voip from the phones on CME. I can dial into the BACD fine from the PSTN, but not from my IP phones. Here is my config: voice service voip allow-connections h323 to h323 dial-peer voice 3500 pots service aa incoming called-number 3500 port 0/2/0:23 ! dial-peer voice 3501 voip destination-pattern 3500 session target ipv4:172.16.101.3 dtmf-relay h245-alphanumeric codec g711ulaw no vad ! dial-peer voice 3502 voip service aa incoming called-number 3500 dtmf-relay h245-alphanumeric codec g711ulaw no vad Eveytime I call the number I get "no circuit" 128A : 67 125333360ms.53 +-1 +3280 pid:20004 Answer 3004 dur 00:00:00 tx:0/0 rx:0/0 22 (no circuit (34)) Telephony 50/0/4 (67) [50/0/4.0] tx:0/0/0ms None noise:0dBm acom:0dBm long duration call detected:n long dur callduration :n/a timestamp:n/a128F : 71 125594800ms.54 +-1 +30 pid:3501 Originate 3500 dur 00:00:00 tx:0/0 rx:0/0 22 (no circuit (34)) IP 0.0.0.0:0 SRTP: off rtt:0ms pl:0/0ms lost:0/0/0 delay:0/0/0ms g729r8 pre-ietf TextRelay: off media inactive detected:n media contrl rcvd:n/a timestamp:n/a long duration call detected:n long dur callduration :n/a timestamp:n/a