I'm not. But to do so I would guess just substitute your interfaces in place of their interfaces. There are probably a bunch of other commands that need replacing. Then paste it into your router.
I have my own dial-plan, IP addresses and directory numbers. It's a little confusing when working through the workbooks, but a diagram seems to help. Looking through the HQ RTR for lab 5b initial You have to change at least the following commands: network-clock-select 1 T1 0/0/0 controller T1 0/0/0 (and other controllers depending on your config) interface Serial0/0/0:23 (which comes from the controller) interface Serial0/0/1:0 for the data. Sub-interfaces need to change also. all dial-peers that point to a physical inteface need to change (911, 91212, 7, 11) Think that's it. Wasn't as bad as I thought. You might have to do some troubleshooting to see why something isn't working, but should not be too much a problem. ________________________________ From: [email protected] [[email protected]] On Behalf Of Andrew [[email protected]] Sent: Wednesday, August 05, 2009 8:04 PM To: [email protected] Subject: [OSL | CCIE_Voice] Home lab - How to load initial server configs ? Hi For a home lab set up, how are you guys installing the initial configs? For the routers / switch it is straight forward (copy / paste), but what about the servers? Andy
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
