Hello,
I am having some issues in displaying the number on PSTN phone while in
SRST mode. I only want the _calling number_ to get displayed on PSTN
phone but I am getting a number with + and then number again in brackets
for e.g. it display this on PSTN phone > From *+16178631001
(*6178631001) while I want it to display like* From 6178631001*.
Please see the debug:
Mar 21 19:34:04.775: ISDN Se0/0/0:23 Q931: Applying typeplan for sw-type
0xD is 0x0 0x1, Calling num 6178631001
Mar 21 19:34:04.775: ISDN Se0/0/0:23 Q931: Sending SETUP callref =
0x0094 callID = 0x8015 switch = primary-ni interface = User
Mar 21 19:34:04.779: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8 callref =
0x0094
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98381
Exclusive, Channel 1
Progress Ind i = 0x8183 - Origination address is non-ISDN
*Display i = '+16178631001' *
Calling Party Number i = 0x0180, '6178631001'
Plan:ISDN, Type:Unknown
Called Party Number i = 0xA1, '12123945001'
Plan:ISDN, Type:National
Mar 21 19:34:04.811: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd = 8
callref = 0x8094
Channel ID i = 0xA98381
Exclusive, Channel 1
Mar 21 19:34:04.871: ISDN Se0/0/0:23 Q931: RX <- ALERTING pd = 8
callref = 0x8094
Progress Ind i = 0x8088 - In-band info or appropriate now
available
--More--
Mar 21 19:34:08.819: ISDN Se0/0/0:23 Q931: TX -> DISCONNECT pd = 8
callref = 0x0094
Cause i = 0x8090 - Normal call clearing
Mar 21 19:34:08.831: ISDN Se0/0/0:23 Q931: RX <- RELEASE pd = 8 callref
= 0x8094
Mar 21 19:34:08.835: ISDN Se0/0/0:23 Q931: TX -> RELEASE_COMP pd = 8
callref = 0x0094
I am not sure but that Display bit in red above might be the problem. I
am using following telephony-service commands:
telephony-service
srst mode auto-provision none
srst dn line-mode dual
max-ephones 5
max-dn 5
ip source-address 10.10.201.1 port 2000
max-redirect 10
voicemail 912123945220
max-conferences 2 gain -6
moh music-on-hold.au
transfer-system full-consult
transfer-pattern .T
secondary-dialtone 9
create cnf-files
Is there a way to get rid of that display thing? Does it depend on PSTN
configuration?
Any help would be much appreciated.
--
Thanks,
Ashar Siddiqui
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com