Thank you guys for the support, I have tried all the suggestions but it did not work.
I will try again tomorrow to see if the same problem still exists. Thanks again. On Tue, Dec 7, 2010 at 9:01 PM, CCIE <givemeccievoice2...@gmail.com> wrote: > Sometimes a simple reload will fix this. > > > On Dec 7, 2010, at 8:18 PM, ccieid1ot <ccieid...@gmail.com> wrote: > > What's the region set? U set ur dial peer to g711. > On Dec 7, 2010 8:18 PM, "study2b ccie" < <study4ccievo...@gmail.com> > study4ccievo...@gmail.com> wrote: > > Hello Experts, > > > > I was on the vRack today and experienced a strange behavior between H323 > and > > CUCM. > > > > BR1 router was running H323, connected to CUCM. > > > > All calls, both inbound and outbound between BR1 and PSTN, failed, they > rang > > once and then get dropped. > > > > Failed message under "Debug ISDN Q931" was: > > > > Bearer capability not implemented > > > > > > When I put the phones into SRST mode, all inbound and outbound calls > worked > > fine. > > > > I could see ISDN status is up with multiple frames established. The > router > > was behaving normally in most ways. > > > > Below is my BR1 configuration, can you help to take a look and let me > know > > what I had missed? > > > > Thank you in advance. > > > > sh run > > Building configuration... > > > > hostname BR1-RTR > > ! > > clock timezone EST -5 > > clock summer-time EDT recurring > > network-clock-participate wic 0 > > network-clock-select 1 T1 0/0/0 > > ! > > ! > > no ip domain lookup > > ip domain name <http://proctorlabs.com>proctorlabs.com > > no ipv6 cef > > ! > > multilink bundle-name authenticated > > ! > > ! > > isdn switch-type primary-ni > > ! > > ! > > ! > > voice service voip > > allow-connections h323 to h323 > > allow-connections h323 to sip > > allow-connections sip to h323 > > allow-connections sip to sip > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > ! > > voice translation-rule 1 > > rule 1 /.*\(....$\)/ /\1/ > > ! > > voice translation-rule 999 > > rule 15 // /\0/ type any subscriber plan any isdn > > ! > > voice translation-rule 1000 > > rule 10 // /\0/ type national national plan isdn isdn > > rule 15 // /\0/ type any subscriber plan any isdn > > ! > > voice translation-rule 1001 > > rule 15 // /+\0/ type any international plan any isdn > > ! > > voice translation-rule 9999 > > rule 15 // /\0/ type any unknown plan any isdn > > ! > > voice translation-rule 91000 > > rule 15 // /\0/ type any subscriber plan any isdn > > ! > > voice translation-rule 91001 > > rule 15 // /\0/ type any national plan any isdn > > ! > > voice translation-rule 91002 > > rule 15 // /\0/ type any international plan any isdn > > ! > > ! > > voice translation-profile 1 > > translate called 1 > > ! > > voice translation-profile 1000 > > translate calling 1000 > > translate called 91000 > > ! > > voice translation-profile 1001 > > translate calling 1001 > > translate called 91001 > > ! > > voice translation-profile 1002 > > translate calling 1002 > > translate called 91002 > > ! > > voice translation-profile 999 > > translate calling 999 > > translate called 9999 > > ! > > ! > > voice-card 0 > > no dspfarm > > ! > > ! > > ! > > ! > > ! > > archive > > log config > > hidekeys > > ! > > ! > > ! > > ! > > ! > > controller T1 0/0/0 > > framing esf > > linecode b8zs > > pri-group timeslots 1-3,24 > > ! > > controller T1 0/0/1 > > framing esf > > linecode b8zs > > channel-group 0 timeslots 1-24 > > ! > > ! > > interface Serial0/0/0:23 > > no ip address > > encapsulation hdlc > > isdn switch-type primary-ni > > isdn incoming-voice voice > > isdn bchan-number-order ascending > > isdn outgoing display-ie > > isdn outgoing ie redirecting-number > > no cdp enable > > ! > > interface Vlan240 > > ip address 10.10.201.1 255.255.255.0 > > ip helper-address 10.10.210.10 > > h323-gateway voip interface > > h323-gateway voip bind srcaddr 10.10.201.1 > > ! > > ! > > ! > > ! > > ! > > control-plane > > ! > > ! > > ! > > voice-port 0/0/0:23 > > translation-profile incoming 1 > > ! > > ! > > ! > > ! > > ! > > dial-peer voice 1 pots > > incoming called-number .T > > direct-inward-dial > > port 0/0/0:23 > > ! > > dial-peer voice 2 voip > > destination-pattern 1... > > session target ipv4:10.10.210.11 > > dtmf-relay h245-alphanumeric > > codec g711ulaw > > no vad > > ! > > dial-peer voice 3 voip > > preference 1 > > destination-pattern 1... > > session target ipv4:10.10.210.10 > > dtmf-relay h245-alphanumeric > > codec g711ulaw > > no vad > > ! > > dial-peer voice 999 pots > > translation-profile outgoing 999 > > destination-pattern 9%911$ > > no digit-strip > > direct-inward-dial > > port 0/0/0:23 > > forward-digits 3 > > ! > > dial-peer voice 1000 pots > > translation-profile outgoing 1000 > > destination-pattern 9[2-9]......$ > > no digit-strip > > direct-inward-dial > > port 0/0/0:23 > > forward-digits 7 > > ! > > dial-peer voice 1001 pots > > translation-profile outgoing 1001 > > destination-pattern 91[2-9].........$ > > no digit-strip > > direct-inward-dial > > port 0/0/0:23 > > forward-digits 11 > > ! > > dial-peer voice 1002 pots > > translation-profile outgoing 1002 > > destination-pattern 9011T > > direct-inward-dial > > port 0/0/0:23 > > prefix 011 > > ! > > ! > > ! > > ! > > gatekeeper > > shutdown > > ! > > ! > > telephony-service > > srst mode auto-provision all > > max-ephones 2 > > max-dn 20 preference 3 no-reg > > ip source-address 10.10.110.2 port 2000 > > max-conferences 8 gain -6 > > transfer-system full-consult > > transfer-pattern .T > > secondary-dialtone 9 > > create cnf-files version-stamp 7960 Dec 07 2010 10:14:21 > > ! > > ! > > ephone-dn 1 octo-line > > number 1002 > > label 1002 > > description +16178631002 > > name +16178631002 > > preference 3 > > ! > > ! > > ephone 1 > > device-security-mode none > > mac-address 001D.E041.DE1B > > type 7961 > > button 1:1 > > ! > > _______________________________________________ > > For more information regarding industry leading CCIE Lab training, please > visit <http://www.ipexpert.com>www.ipexpert.com > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
